User manual WHIRLPOOL AZA-HP7040 PROGRAM CHART

[. . . ] Select the option required by pressing the corresponding button. The indicator lamp above the relevant button lights up to confirm your selection. A fast blinking lamp indicates a wrong selection is made (incompatible options). Press the button again to cancel the option. [. . . ] 2. 5 kg Cotton - synthetic blend 3. 5 kg Textiles made of silk Max. 2. 5 kg Textiles made of wool 1 kg Laundry that contains downs 3 kg Cupboard dry + Cupboard dry * Iron dry X X X X X X — Delicate plus Mixed load Silk Wool finish Down Laundry is aired, refreshed and loosen up for 30 minutes without heating. All textiles. Completes drying (suitable for all fabrics). X 10’ - 180’ X X X — — X X 10’ - 180’ * Test programmes according to EN 61121, tested with maximum rated load capacity. HOW TO PROCEED IF. . . . . . you want to check the dryer yourself first: (If your machine is not functioning correctly, please check the following points before calling the customer service - also refer to relevant chapter in the Instructions for Use) • Has the correct drying programme been selected?• Has the cycle been interrupted (door opening, full water container)?• Was the inserted laundry too wet (washing machine spin speed less than 1000 rpm)?• Is the door filter dirty (filter indicator light on)?• Is the bottom filter dirty (for more information, refer to the Instructions for Use)?• Is the room temperature too high?• Is the “End” and “Anticrease” indicator lamp lighting up?The drying cycle is complete and the laundry can be taken out. • If the drying result does not meet your expectation, select a more dry programme or use the dryness adjustment option (if available) to optimize the drying result. • • • • • • • • • • • • • • • • • Is the plug properly inserted into the mains electricity socket?Has the “Start (Pause)” button been pressed?Has the start delay option been selected?Has the water container been inserted correctly?Is the bottom filter clean and inserted correctly?Has the bottom filter been inserted correctly?Have all lint on the bottom filter seal and the door seal been wiped away?Has the water container been inserted correctly?If the direct drain connection is used, is it tight?Is the dryer levelled? Drying takes too long/ Laundry is not dry enough The dryer does not operate (after a power failure, always press the “Start (Pause)” button) Door filter, water container or bottom filter indicator lamp on Water droplets underneath the dryer . . . you want to care of and clean your dryer: • Brush lint using a soft brush or your fingertips. • Pull the handle to remove the water container. • Replace the water container when empty by pushing it completely back in place. [. . . ] The blinking lines indicate that the calculation is running. The remaining time will be updated. Reset During the selection phase of the programme, pressing this button will switch off all settings of selected options. The tumbling phase can be stopped at any time either by pressing any button, by rotating the programme selector or by opening the door. Dry time adjustment Turn the programme selector knob to “Drying Time” position. Press the button “Drying time” to select the duration of cycle in ten minutes steps up to 180 minutes. Additional reverse With this option the drum will turn during the drying cycle more often against the main turning direction than in a normal cycle. [. . . ]