User manual WHIRLPOOL AZB9120

[. . . ] To switch the dryer on again turn the programme selector knob to “Off” (“0”) and afterwards to the desired programme. Select the option required by pressing the corresponding button. The indicator lamp above the relevant button lights up to confirm your selection. A fast blinking lamp indicates a wrong selection is made (incompatible options). [. . . ] Terry towels, dry towels, bed linen, underwear Similar types of laundry which do not require ironing such as: dry towels, bed linen, underwear, baby clothes, T-shirts, cotton socks. Laundry which requires ironing such as: bed and table linen, dry towels, T-shirts, polo shirts, work clothes. Laundry with thick, multi-layered areas such as: bed and table linen, track suits, anoraks, blankets. Laundry which does not require ironing such as: shirts, blouses, T-shirts, sportsware. Laundry which requires ironing such as: trousers, dresses, skirts, shirts, blouses. Cotton or linen hot wash / coloured laundry Gentle Options Approximate drying times (in minutes) Pause Dry plus Start delay Délicat X Séchage+ Départ différé Very wet load Wet load Séchage renforcé Cupboard dry + X X X 195 165 Prêt à ranger Extra dry X X X X 170 150 Cotton Prêt à porter Cupboard dry* Coton Max. 9. 0 kg X X X X 150 125 Prêt à repasser Iron dry* X X X X 120 110 Prêt à ranger Extra dry Synthetic Synthetic, mixed fibre or cotton easy care (ironing not required) laundry X X X X 90 65 Prêt à porter Cupboard dry* Synth. Max. 4. 5 kg X X X X 65 45 Prêt à repasser Iron dry X X X X 55 40 Airing Laundry is aired, refreshed and loosen up for 30 minutes without heating. All textiles. Fraîcheur All textiles. – X – X – – Drying times Completes drying Minuterie 10’ 20’ 30’ 40’ 60’ 90’ X X – X 10’ 20’ 30’ 40’ 60’ 90’ *Test programmes according to EN61121. 2 HOW TO PROCEED IF… . . . you want to check the dryer yourself first: (If your machine is not functioning correctly, please check the following points before calling the customer service – also refer to relevant chapter in the Instructions for use) Drying takes too long / Laundry is not dry enough  Has the correct drying programme been selected? Has the cycle been interrupted (door opening, full water container)? Was the inserted laundry too wet (washing machine spin speed less than 1000 rpm)? Is the lint filter dirty (filter indicator light on)? Is the heat exchanger dirty (for more information, refer to the Instructions for use)? Is the “End” and “Anticrease” indicator lamp lighting up?The drying cycle is complete and the laundry can be taken out.  If the drying result does not meet your expectation, select a more dry programme or use the dryness adjustment option (if available) to optimize the drying result. Sort the laundry after thickness and material and dry again.       Is the plug properly inserted into the mains electricity socket?Has the “Start (Pause)” button been pressed shortly after a programme is selected?(If not, the dryer will switch off. )  Has the start delay option been selected? Has the water container been inserted correctly? Is the heat exchanger clean and inserted correctly? Has the heat exchanger been inserted correctly? [. . . ] Press the “Start (Pause)” button to confirm the final selection and to start the dryer. The lamps above the programme selector knob are flashing to indicate the selected time. During the countdown, the drum will turn from time to time to redistribute the laundry and the pump will start to pump water in the water container. To cancel or change the previously set time delay, set the index of the programme selector knob to “off” “(0)” position, or open the door. Filter The indicator lamp lights up when the filter and/or heat exchanger including housing needs to be cleaned. [. . . ]