User manual WHIRLPOOL BCB36VA PRODUCT FICHE

[. . . ] Any damage must be reported to the dealer within 24 hours of delivery of the appliance. Wait at least two hours before switching the appliance on, to ensure that the refrigerant circuit is fully efficient. Installation and the electrical connection must be carried out by a qualified technician according to the manufacturer’s instructions and in compliance with the local safety regulations. Clean the inside of the appliance before using it. SAFEGUARDING THE ENVIRONMENT 1. [. . . ] These factors should be taken into account when setting the thermostat position. • The space between the shelves and the rear wall of the refrigerator ensures the free circulation of air. • Do not place food in direct contact with the rear wall of the refrigerator compartment. • Do not place hot food in the compartments. • Store liquids in closed containers. • Storing vegetables with high water content can cause condensation to form: this does not affect correct appliance operation. Storing food in the refrigerator compartment Place the food as shown in the figure. Dairy products, cheese Temperature adjustment The temperature is factory set to +5°C (display 7). To change the temperature setting, press the buttons (8) or (9) on the control panel, until the required value is obtained. Settable temperature limit: • +2 °C coldest temperature • +8 °C warmest temperature 22 USING THE REFRIGERATOR COMPARTMENT (continuation) Fast cooling function (“Party”) The use of this function is recommended when placing a very high quantity of food in the refrigerator compartment. By pressing the button (15) it is possible to increase the cooling speed of the foods inside the refrigerator compartment. Making ice cubes • Fill the ice cube tray up to 2/3 with water and place in the freezer compartment. • Do not use sharp or pointed objects to detach the tray if it is stuck to the bottom of the freezer grill or drawers. • Bend the ice tray slightly to facilitate removal of the cubes. 26 MAINTENANCE AND CLEANING Before carrying out any cleaning or maintenance operation, switch the product off by pressing button (1) on the control panel for 3 seconds, then unplug the appliance or disconnect it from the power supply. Cleaning the freezer compartment The freezer should be defrosted once or twice a year, or when too much frost has formed on the refrigerant grills. The formation of frost on the refrigerant grills is a normal occurrence. The amount and rate at which frost accumulates depends on room conditions and how often the door is open. Frost tends to form more on the upper grills. It is advisable to defrost when the freezer is nearly empty. If possible, activate the “Fast freeze” function 24 hours before defrosting the compartment. This will ensure that the food stored in the freezer compartment remains as cool as possible while defrosting takes place. Open the freezer door and remove all the food, wrapping it close together in sheets of newspaper and put in a very cool place or in a portable cooler. [. . . ] Should the display not go off when the door is correctly closed, contact the Customer Care Centre. • First check point 1, then: - Disconnect the appliance from the power supply. To access the lamp refer to the instructions and diagram on the attached product sheet. - Check the lamp and, if necessary, replace it with a new one (available only from the Customer Care Centre). [. . . ]