User manual WHIRLPOOL BCE 822/AV PROGRAM CHART

[. . . ] Same as the spin cycle in the “Cotton” programme. € — ❉: 1) optional / Yes : dosing required For improved garment care, spin speed is restricted in these programmes. The wool and handwash cycles of this machine have been tested and approved by The Woolmark Company for the washing of Woolmark garments labelled as “machine wash” or “hand wash” provided that the garments are washed according to the instructions on the garment label and those issued in this programme chart. Fm Page 2 Wednesday, September 23, 2009 5:47 PM The Sensor Technology automatically adapts Programme Time, Water and Energy consumption to the size of your wash load. [. . . ] START DELAY The “Start delay” allows to run the machine at the consumer’s convenience, for example at night when electricity is cheaper. Do not use liquid detergent when activating the “Start delay”. • Select programme , temperature , spin speed and options. € Press the Start delay button to select one of the delay time steps between 0:30 and 23:00 hours. € Press the “Start (Pause)” button; the light stops blinking and becomes solid. The countdown of the delay time begins; the clock symbol next to the delay time and the colon between hours and minutes blink. € The time delay indication disappears when the programme starts and it is replaced by the remaining programme time. to cancel the “Start delay” . Before you press the “Start (Pause)” button: • Press the “Reset/Drain” button, or set the start delay time to “0:00” - the delay time disappears after a few seconds. After having pressed the “Start (Pause)” button: Press the “Start (Pause)” button - the delay time disappears from the display; press “Start (Pause)” again to start the selected programme immediately. RED FAILURE INDICATIONS If one of the red failure indications on the display lights up, refer to the “Troubleshooting Guide” in your “Instructions for Use”. € If spin speed “0” is selected, the final spinning is cancelled but • Add an appropriate amount of in-wash additive for stain intermediate spin peaks remain during rinse. The water is removal (powder) to the main wash chamber, together with drained out only. Your detergent (only use powder detergent with this option). If there is a programme setting which you use frequently, the • Appropriate for use of stain removers and bleaches on oxygen appliance offers the possibility to save one setting for each basis. chlorine or perborate bleaches must not be used!€Prewash” button programme so that it can be used again by just pushing one button. € Only for heavily soiled loads (for example sand, granular dirt) • Select the desired programme, temperature, spin speed and sensible. Increases the cycle time by approximately 15 min. Option(s), push and hold the “Favourites” button for at least 3 • Do not use liquid detergent for the main wash when activating seconds. The lamp of the “Favourites” button shortly blinks and the “Prewash” option. Then lights up - the programme setting is saved. [. . . ] Press the “Start (Pause)” button to pause the programme. Select the new programme, temperature, any options and another spin speed if you want. press the “Start (Pause)” button again. The new programme continues at the same position where the previous programme was interrupted. [. . . ]