User manual WHIRLPOOL CW 492/1 W INSTRUCTION FOR USE

[. . . ] The light comes on and goes off at the end of the programme. The “Half Load” function can be used with programmes marked with an *. Programme chart Programmes Loading instructions Detergent 2) A X X X X Consumption 3) Litres kWh Minutes B X X X Pre-Rinse Quickwash Bio 1) (*) Normal (*) Intensive 1) 2) cold 40°C 50°C 60°C 70°C Crockery to be washed later. Lightly soiled crockery with no driedon food. Recommended programme for heavily soiled crockery, especially suitable for pans and saucepans. 3) 5. 0 13. 0 16. 0 16. 0 17. 0 0. 02 0. 70 1. 24 1. 35 1. 65 10 30 133 120 145 Reference programme for energy label in compliance with EN 50242 regulations; Refer to “User instructions”; The data relevant to programmes are values obtained in the laboratory in conformity with Standard EN 50242. [. . . ] In practical use there may be time variations or leaps depending on different loads, function options, water temperatures or hardness and different power supply voltages. Important information for Test Laboratories: For detailed information on the EN comparison test and other tests, contact the following address: “nk_customer@whirlpool. com”. 5019 696 93215 (We reserve the right to make technical modifications) How to use the appliance Further indications are given in the single chapters and in the user instructions. Switch on the appliance Automatic start by turning the programme selector knob (in case of retractable knob, first press the knob to access it). Large compartment A: With each wash cycle. Small compartment B: For programmes with pre-wash only. If using combined action dishwasher tabs, follow the user instructions!Electric indicator on control panel (if provided). How to fill the detergent dispenser A BC Check the rinse aid level Check the regeneration salt level On models with water softener system only. Electric indicator on control panel (if provided). Load the racks Close the dishwasher door, turn on the water tap Select a programme Refer to the dishwasher loading instructions. Select the desired programme. The corresponding indicator lamp comes on. Select options If necessary (and if provided) the corresponding indicator lamp lights up. Press the Start button The selected programme is then memorised (even in the event of power failure). “Change programme in progress” Press the START button for 2 sec. until the Start indicator lamp switches off; Select another programme and press the START button again. - Only open the dishwasher if necessary (Warning: beware of hot steam). • The spray arms must be able to turn freely. • Remove any impurities obstructing the water flow *. If crockery is not perfectly dry If crockery is not perfectly clean • Insufficient rinse aid. • The water jet does not reach the crockery. • Spray arm nozzles clogged. • Incorrect detergent/detergent too old. • Use a good quality detergent. Sandy or grainy residues • Clogged filters. • Filters incorrectly assembled. • Check filters regularly/if necessary clean *. • Depending on the material, if necessary use a detergent with a greater whitening power. Colour of plastic parts faded Deposits on crockery • removable • Tomato/carrot juice, . . . • Streaks on the crockery/glasses. • Layer of salt on crockery/glasses. • Increase the rinse aid dosage *. • Close the salt container lid properly *. • Change water hardness setting, if necessary add salt *. [. . . ] • Change water hardness setting, if necessary add salt *. • Use suitable glasses. • not removable • Insufficient water softening, calcium deposits. Opaque glasses/ glasses • Cannot be washed in the dishwasher. not sparkling Rust on cutlery Identifying appliance faults • Not made of stainless steel. • The START indicator lamp flashes. [. . . ]