User manual WHIRLPOOL DWH M40 W INSTRUCTION FOR USE

[. . . ] (Refer to the separate installation instructions booklet) 3. Water inlet and drain: • Observe any special regulations issued by your local Water Board. water supply pressure: 0 , 03 - 1 , 0 MPa. €¢ Make sure the inlet and drain hoses are kink-free and are not crushed. [. . . ] Long-handled utensils must be arranged horizontally in the upper rack, with the sharp end facing away from the front of the appliance. €¢ Before cleaning or carrying out maintenance, switch off the appliance, disconnect the mains plug and turn off the water tap. €¢ If a fault occurs, switch off the appliance and turn off the water tap. €¢ On completion of the programme switch off the dishwasher and turn off the water tap. €¢ Repairs and technical modifications must be carried out exclusively by a qualified technician. €¢ The water in the dishwasher is not potable. €¢ Do not store inflammable liquids near the dishwasher. €¢ Do not operate the appliance in the open air. Resistance to frost If the appliance is placed in surroundings exposed to the risk of frost, it must be drained completely. Turn off the water tap, remove the flexible inlet and outlet hoses, and let all the water run out. For appliances with water stop system: The water inlet hose and plastic casing contain electrical components. Do not therefore cut the hose or immerse the plastic casing in water. If the hose is damaged switch off the appliance immediately. The appliance must be used at temperatures between 5°C and 45°C. This appliance is marked according to the European directive 2002/96/EC on Waste Electrical and Electronic Equipment (WEEE). By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. The symbol on the product, or on the documents accompanying the product, indicates that this appliance may not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. Disposal must be carried out in accordance with local environmental regulations for waste disposal. For more detailed information about treatment, recovery and recycling of this product, please contact your local city office, your household waste disposal service or the shop where you purchased the product. Fm Page 16 Tuesday, January 30, 2007 11:07 AM HOW TO FILL THE SALT CONTAINER From a water hardness category of 1–2 (medium), before using the dishwasher, fill the salt container with regeneration salt (to find out the hardness level of water in your area, contact your local Water Board or check the last bill you received). If the water hardness level does not correspond to position 3 on the selector (setting on delivery) or if the water hardness level changes: Setting the correct water hardness level: Set the water hardness by turning the selector (A) inside the salt container energically. [. . . ] If you use detergents in tablet form, follow the manufacturer's directions for use. If you use multi-action dishwasher detergents that incorporate rinse aid and regeneration salt, follow the directions below: • products that incorporate the rinse aid enhance the detergent action only with some programs. €¢ products that do not require using regeneration salt may be used only in areas with specific water hardness level. read the product user instructions carefully. [. . . ]