User manual WHIRLPOOL DWI 009 INSTRUCTION FOR USE

[. . . ] Values may vary in relation to usage, e. g. : different loads, water temperatures - above or below 15°C - as well as water hardness and power supply voltage, etc. 5019 696 93179 (We reserve the right to make technical modifications) FIORI/I/FD/GB How to use the appliance Further indications are given in the single chapters and in the user instructions. Open the door, switch on the appliance Press the ON button. Large compartment A: How to fill the detergent dispenser With each wash cycle. Small compartment B: For programmes with pre-wash only. A BC Check the rinse aid level Mechanical indicator C. Electric indicator on control panel (if provided). Check the regeneration salt level On models with water softener system only. Electric indicator on control panel (if provided). [. . . ] Refer to the dishwasher loading instructions. The last programme selected will light up. Press the button until the desired programme lights up. Load the racks Select a programme Select options If necessary (and if provided) the corresponding indicator lamp lights up. “Change programme” Press the Start button The selected programme is then memorised (even in the event of power failure). Press the START button for 2 sec. until the Start indicator lamp switches off; Select another programme and press the START button again. Turn on the water tap close the dishwasher door Wash cycle - Only open the dishwasher if necessary (Warning: beware of hot steam). - If the appliance is switched off during a wash cycle, when switched on again it will resume the cycle from where it was interrupted. At the end of the programme an acoustic signal will sound. Only after the START button has switched off: press the OFF button. Warning: when the door is opened steam comes out!Unload the appliance, starting from the lower rack. Switch off the appliance Turn off the water tap, unload the racks FIORI/II/FD/GB Dishwasher loading instructions and racks provided Upper rack: Multi-purpose support (A): Depending on the position, for long-handles utensils, cups and glasses. May be used in three different positions. • Arrange crockery so that items do not touch each other. • • • • • Follow recommended detergent dosage. The spray arms must be able to turn freely. Remove any impurities obstructing the water flow *. Use a good quality detergent. Sandy or grainy residues • Clogged filters. • Filters incorrectly assembled. • Check filters regularly/if necessary clean *. • Depending on the material, if necessary use a detergent with a greater whitening power. Colour of plastic parts faded Deposits on crockery • removable • Tomato/carrot juice, . . . • not removable • • • • Streaks on the crockery/glasses. Insufficient water softening, calcium deposits. • • • • Increase the rinse aid dosage *. Close the salt container lid properly *. Change water hardness setting, if necessary add salt *. Opaque glasses/ glasses • Cannot be washed in the dishwasher. not sparkling Rust on cutlery Identifying appliance faults • Not made of stainless steel. [. . . ] Change water hardness setting, if necessary add salt *. Opaque glasses/ glasses • Cannot be washed in the dishwasher. not sparkling Rust on cutlery Identifying appliance faults • Not made of stainless steel. • The START indicator lamp flashes. • Use suitable glasses. • Use suitable cutlery. • Ensure that the filter assembly is not clogged and if necessary clean it *. [. . . ]