User manual WHIRLPOOL EP 3494 INSTRUCTION FOR USE

[. . . ] • Before any maintenance on the dryer disconnect it from the mains supply. • Do not operate the dryer if it has been damaged during transport. Contact one of our After-Sales Service technicians. • Mains cable replacement is only to be carried out by After-Sales Service. [. . . ] The dryer is built from reusable materials. The dryer must be disposed of in compliance with local waste disposal regulations. Before scrapping, cut off the power cable so that the dryer cannot be connected to the mains. Child safety: Children must not be allowed to play with the dryer. General recommendations: Always set the programme/time selector knob to the “0” position after use. This prevents the dryer from being switched on accidentally. Before cleaning or carrying out maintenance, switch off the dryer and disconnect it from the mains supply. To clean the outside of the dryer, use a neutral detergent and a damp cloth. Clean the lint filter at the end of every drying cycle: 1. Remove lint using a soft brush or your fingertips. • Push the filter firmly back into place. • Wipe away lint from the door seal and the door using a damp cloth. • If the lint filter mesh is clogged, clean it with water and a soft brush. • If necessary, the power cable may be replaced with an identical one obtained from our After-Sales Service. The power cable must only be replaced by a qualified technician. • EC Declaration of Conformity This dryer has been designed, constructed and distributed in compliance with the safety requirements of EC Directives: • 73/23/EEC Low Voltage Directive • 89/336/EEC EMC Directive • 93/68/EEC CE Marking Directive. 2. • • • • • • • • 3. • The dryer must be used in the household for the described uses. • 4. 5. • • • • 12 DESCRIPTION OF THE DRYER A. Door To open the door: pull the handle To close the door: push gently until closed. Filter A B C D Reminder - Maintenance and Cleaning Clean the lint filter at the end of every drying cycle: Open the door. [. . . ] Replace the contact pin in the inside of the door (top). E F E 15 TROUBLESHOOTING GUIDE / AFTER-SALES SERVICE Troubleshooting Guide If a fault occurs, before contacting our AfterSales Service, make the following checks to try and remedy the problem: Drying takes too long / laundry is not dry enough: • • Was the correct programme selected?Was the inserted laundry too wet (Washing machine spin speed less than 800 rpm)?Is the lint filter dirty (filter indicator lamp on)? After-Sales Service If, after carrying out the above checks the malfunction persists or appears again, turn the dryer off and call our After-Sales Service (refer to guarantee). Please specify: • • • The nature of the fault. [. . . ]