User manual WHIRLPOOL ERRES2 INSTRUZIONI PER L'USO

[. . . ] 0 Same as the last rinse and the final spin in the “Cotton” programme. Same as the spin cycle in the “Cotton” programme. €” ❉: 1) optional / Yes : dosing required For improved garment care, spin speed is restricted in these programmes. Fm Page 2 Thursday, March 15, 2007 5:28 PM CONSUMPTION DATA Programme Cotton / Antibacterial Cotton Cotton with “Eco”*** Cotton SuperEco Synthetics Synthetics Big Items Delicates Daily load Quick wash Wool Handwash Lingerie Temperature (°C) 95 60 60 40 60 60 40 40 30 40 30 40 40 30 Load (kg) 8. [. . . ] The time display shows the remaining programme time. Due to variations in load and temperature of inlet water, the remaining time is newly calculated in certain programme phases. If this is the case, an animation appears on the time display. €œDOOR OPEN” INDICATION Before starting and after end of a programme, the lamp lights to show that the door can be opened. As long as a wash programme is running, the door remains locked and must on no account be forced open. In case you have an urgent need to open it during a running programme, refer to “Cancel (Reset) a running programme before the end”. RED INDICATIONS “Service” Lighting up of the “Service” indication can be caused by a fault in an electrical component. Refer to the “Troubleshooting Guide” in your Instructions for Use; if the fault persists, contact our After Sales Service. “Water tap closed” The appliance has no or insufficient water supply. Open the water tap; if the indication still lights up, refer to the “Troubleshooting Guide” in the Instructions for Use. “Clean pump” Waste water is not pumped out. Check whether the drain hose is kinked or the filter must be cleaned; in the latter case refer to the Instructions for Use (“Removing the Filter”). PROGRAMME END • All the lights of the programme sequence indicator are off, and the “Door open” indication lights up. Turn the programme selector to the “Off/O” position. Leave the door ajar to allow the drum to dry. cHANGE PROGRAMME AND/OR OPTIONS AFTER PROGRAMME START 1. Press the “Start/Pause” button to pause the programme. Select the new programme (with temperature), any options and another spin speed if you want. The new programme continues at the same position where the previous programme was interrupted. Do not add detergent for this programme. cANCEL (RESET) A RUNNING PROGRAMME BEFORE THE END The “Reset” button cancels a programme before the end. €¢ Press the “Reset” button for at least 3 seconds. [. . . ] €¢ Selectable only on the lowest temperature step of each programme. €œEasy ironing” button • Can be used together with “Cotton”, “Synthetics” and “Daily load” programmes to make ironing easier. €¢ Increases the water quantity and the clothes are spun very gently. “Intensive rinse” button • More water is added and rinse cycle is prolonged. [. . . ]