User manual WHIRLPOOL EXCELLENCE 2489E PRODUCT FICHE

[. . . ] Remove the transport bolts • The washing machine is fitted with a transport bolts to avoid any possible damage to the interior during transport. Before using the washing machine, it is imperative that the transport bolts are removed 3. • • • Install the washing machine Remove the protective foil from the control panel Move the appliance without lifting it by the worktop Install the appliance on a solid and level floor surface, preferably in a corner of the room • Make sure that all four feet are resting firmly on the floor and check that the appliance is perfectly level (use a spirit level) 4. Water inlet • Connect the water supply inlet hose in accordance with regulations of your local water company • Water inlet: • Tap: • Water pressure (flow pressure): Cold water only 3/4” threaded hose connection 100-1000 kPa (1-10 bar) 6. [. . . ] Insert the filter with the guide pin upwards and screw it in clockwise to the stop (handle horizontal). Fold the cover up and lock it. Before using the washing machine again: 1. 1 litre of water into the detergent drawer to reactivate the Eco system. Reinsert the plug in the socket. Red spot 45. 0° 100. 0 LPI 40105150bGB. fm Page 25 Friday, July 15, 2005 1:03 PM We recommend that you check and clean the filter regularly, at least two or three times a year. Especially: • When the appliance does not drain or spin properly • If the pump is blocked by a foreign body (e. g. buttons, coins or safety pins) IMPORTANT: make sure the water has had time to cool before draining the appliance. Open the filter cover with the help of the coloured insert from the detergent container (shape depending on model). Open the filter but do not withdraw it completely. Slowly turn the handle anticlockwise until the water drains out. Wait until all the water has drained off. Now unscrew the filter completely and remove it. Clean the filter and the filter chamber. Insert the filter with the guide pin upwards and screw it in clockwise to the stop (handle horizontal). Pour about 1 litre of water into the detergent drawer to reactivate the Eco system. Check that the foreign body trap is seated properly and tightly in place. Select a programme and start it. Before emptying the residual water, switch the appliance off and unplug it from the mains socket. Open the cover to the foreign body trap. Open the filter cover with the help of the coloured insert from the detergent container. Open the filter but do not withdraw it completely. Slowly turn the handle anticlockwise until the water drains out. Wait until all the water has drained off. Now unscrew the filter completely and remove it. Tilt the appliance forwards carefully to allow the water to flow out. [. . . ] approved fuse to BS 1362 type and proceed as follows: 1. Fit replacement 13A fuse into fuse cover. Important: The fuse cover must be refitted when changing a fuse and if the fuse cover is lost the plug must not be used until a correct replacement is fitted. Correct replacement are identified by the colour insert or the colour embossed in words on the base of the plug. [. . . ]