User manual WHIRLPOOL FR 2202P PRODUCT FICHE

[. . . ] Dairy products, preserves, cheese, butter 3. Bottles Note: • Cover food to prevent it drying out. • Hot food must be allowed to cool properly before being placed in the refrigerator. • Make sure sufficient space is left for air to circulate around the food. [. . . ] • Avoid contact between already frozen food and food that has yet to be frozen (approx. • After 24 hours turn the thermostat knob (1) back to the normal position. Important: Wrap and seal the food in: • Aluminium foil, cling film, watertight plastic bags, polythene containers with lids or special freezer containers. When purchasing frozen food products: • Ensure that the packaging is not damaged (frozen food in damaged packaging may have deteriorated). If the package is swollen or has damp patches, it may not have been stored under optimal conditions and defrosting may have already begun. • Transport products in a thermally insulated cool bag. • When shopping, leave frozen food purchases until last. • Once at home, place the frozen foods immediately in the freezer. • If food has defrosted even partially, do not re-freeze it. • Avoid subjecting foods to temperature variations. Observe the "best before" date on the package. • Is the plug properly inserted in the socket?• Do the household electrical system protection devices work correctly?Water collects at the bottom of the refrigerator compartment. • Is the thermostat setting correct?• Is the defrost water drain blocked? y 6. y Perform the checks for point 4, and then: • Disconnect the appliance from the power supply, check the light bulb and, if necessary, replace it with a new one: - traditional light bulb (max 25W) Or - LED bulb (with the same characteristics), only available from the After-Sales Service • Removing the light bulb: Unscrew the bulb anticlockwise as shown in the figure. 14 AFTER-SALES SERVICE Before contacting After-Sales Service: 1. See if you can solve the problem yourself with the help of the “Troubleshooting guide”). Switch the appliance on again to see if the problem has been solved. If it has not, disconnect the appliance from the power supply and wait for about an hour before switching on again. If the problem persists after this course of action, contact After-sales Service. Specify: • the nature of the problem, • the model, • the Service number (the number after the word SERVICE on the rating plate on the inside of the appliance), • your full address, • your telephone number and area code. Note: The direction of door opening can be changed. [. . . ] Clean the interior (see “How to defrost and clean the appliance”). Check the door seal is not damaged or deformed, especially after installation or reversal of door opening. • • • • Electrical connection • Ensure that the voltage indicated on the appliance rating plate corresponds to the domestic supply voltage. • Regulations require that the appliance is earthed. The Manufacturer declines all liabilities for injury to persons or damage to property resulting from failure to observe these regulations. [. . . ]