User manual WHIRLPOOL FT 338 SB SCHEDA PROGRAMMI

[. . . ] Spin speed rpm 1300 “Prewash” can be additionally selected for heavily soiled laundry at any temperature. Notes ❉ ❉ 1) ❉ ❉ ❉ 1) ❉ 1) “Prewash” can be additionally selected for 1000 1) heavily soiled laundry. 1300 In this programme the spin speed should be adapted to the fabrics. 1300 – – 1000 1) If you select “Rinse Hold” do not leave 1000 1) items to soak for too long. [. . . ] € After the “Start Delay” has been started: The preset number of hours can be reduced by pressing the “Start Delay” button again; please note, however, that the washing programme starts IMMEDIATELY, as soon as you activate it again with the Start Delay switch 3 setting. To increase the number of hours preselected, first turn the programme selector switch to the “Off” position. Then set the programme and the additional options again and select the desired number of hours. PROGRAMME START After you have selected the programme and the additional option, the indicator light over the “Start” button flashes. Turn on the tap and start the programme by pressing the “Start” button. Now the indicator light above the button goes on. In addition, all programme phases are indicated by the associated lights. After the end of a programme phase the associated indicator light goes out. Thus the programme sequence indicator moves from left to right across the wash, rinse and spin phases. At the end of the programme only the “End” indicator is still on. DOOR LOCKED INDICATOR As long as a washing programme is running, the lamp lights up to show that the door cannot be opened. When the lamp goes off, the door can be opened again. If “Start” has been pressed, but the door is not latched, the “Door locked” indicator flashes for 10 seconds. The door must be pushed shut within this time. After the 10 seconds, the “Door locked” indicator goes out and the “Start” button flashes. The door must then be opened and closed again and the “Start” button must be pressed. “TROUBLE” INDICATORS “Pump” Waste water is not pumped out. Check wether the drain hose is kinked or the filter must be cleaned; in the latter case refer to the Instructions for Use (“Removing the Filter”). “Water Tap” The appliance has no or insufficient water supply. Open the water tap; if the indication still lights up, refer to the “Troubleshooting Guide” in the Instructions for Use. Set the programme selector knob to the “Off” position . RESELECT AFTER PROGRAMME START A newly-selected programme will continue in the same programme section during which the current programme was interrupted. [. . . ] €Prewash” button • Only for heavily soiled laundry (for example sand or granular dirt). € This option is particularly suitable for areas with very soft water, washing baby linen and helps people with detergent allergies. €Rinse Hold” button • The laundry remains in the last rinse water without being spun: discoloration of the laundry and additional creasing are prevented. Note: The programme has reached the “Rinse Hold” when the corresponding light flashes. [. . . ]