User manual WHIRLPOOL GI15NFLXS DIMENSION GUIDE

[. . . ] All safety messages will follow the safety alert symbol and either the word “DANGER” or “WARNING. € These words mean: DANGER WARNING You can be killed or seriously injured if you don't immediately follow instructions. You can be killed or seriously injured if you don't follow instructions. All safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and tell you what can happen if the instructions are not followed. [. . . ] Kit Contains: ■ ■ ■ ■ ■ Rear View A B ■ ■ ■ ■ ■ Drain pump kit Part Number 1901A ⁵⁄₈" ID x 5¹⁄₈" drain tube (ice maker bin to drain pump reservoir inlet) ¹⁄₂" ID x 10 ft (3 m) drain tube hose (drain pump discharge to household drain) ⁵⁄₁₆" ID x 32" (81 cm) vent tube (drain pump reservoir vent to ice maker cabinet back) Cable clamps (secures vent tube to back of ice maker) (3) #8-32 x ³⁄₈" pump mounting screws (secures drain pump to baseplate and clamps to back of ice maker) (5) ⁵⁄₈" small adjustable hose clamp (secures vent to drain pump) ⁷ ₈" large adjustable hose clamp, (secures drain tube to ice maker bin and drain pump reservoir inlet) (3) Rear panel (2) Instruction sheet C A. Inlet water tube clamp and supply line connector 4 If Ice Maker Is Currently Installed NOTE: If ice maker is not installed, please proceed to “Drain Pump Installation” section. Push the selector switch to the Off position. Drain Pump Installation NOTE: Do not kink, smash or damage tubes or wires during installation. See “Rear Panel” illustration for 5 screw locations. Pull rear panel away from the drain tube and discard. wARNING Rear Panel A Electrical Shock Hazard Disconnect power before servicing. Replace all parts and panels before operating. Failure to do so can result in death or electrical shock. Wait 5 to 10 minutes for the ice to fall into the storage bin. Unscrew the drain cap from the bottom of the water pan located inside the storage bin. Connect ice maker to water supply and install ice maker as specified by the product installation instructions. The ideal installation has a standpipe with a 1¹⁄₂" (3. 08 cm) PVC drain reducer installed directly below the outlet of the drain tube as shown. 54 cm) air gap between the drain hose and the standpipe. IMPORTANT: A drain pump is necessary when a floor drain is not available. Failure to follow these instructions can result in death, fire, or electrical shock. Wait for rinsing cycle, approximately 5 minutes, to be sure the ice maker is operating properly. 4 cm) from front of door, with or without the ³⁄₄" (1. The drain should also be centered from left to right (7⁵⁄₁₆" [18. 56 cm] from either side of the ice maker). Remove the 2 hex-head screws located under the stainless steel door wrap panel flange on the bottom of the door. [. . . ] NOTE: On some models, remove the holder by lifting up on the ice scoop holder and then out. – Wash the ice scoop holder along with the other interior components using the following instructions. – Replace the ice scoop holder by replacing the screws or on some models, pushing in on the holder and then down. Remove the mounting screw that holds the water pan in place. [. . . ]