User manual WHIRLPOOL GSXS 4000 PRODUCT FICHE

[. . . ] The last programme selected will light up. Press the button until the desired programme lights up. If necessary (and if provided) the corresponding indicator lamp lights up. The selected programme is then memorised (even in the event of power failure). [. . . ] “Change programme” Press the START button for 2 sec. until the Start indicator lamp switches off; Select another programme and press the START button again. Press the START button Turn on the water tap close the dishwasher door - Only open the dishwasher if necessary (Warning: beware of hot steam). - If the appliance is switched off during a wash cycle, when switched on again it will resume the cycle from where it was interrupted. At the end of the programme an acoustic signal will sound. Only after the START button has switched off: press the OFF button. Warning: when the door is opened steam comes out!Unload the appliance, starting from the lower rack. Wash cycle Switch off the appliance Shut off the water tap, unload the racks Dishwasher loading instructions and racks provided Upper rack: Multi-purpose support (A) : Depending on the position, for long-handles utensils, cups and glasses. May be used in three different positions. Crockery holders (B): Depending on the position, for example plates, cups and long-stemmed glasses. Revolving glass support (C) 2): Depending on the position, for example small or longstemmed glasses. 1) depending on the model Half Load: Load the upper rack only. • Follow recommended detergent dosage. • Select a more intense wash cycle. • The spray arms must be able to turn freely. • Remove any impurities obstructing the water flow *. • Check filters regularly/if necessary clean *. • Depending on the material, if necessary use a detergent with a greater whitening power. Sandy or grainy residues Colour of plastic parts faded Deposits on crockery • removable • Clogged filters. • Tomato/carrot juice. . . • Streaks on the crockery/glasses. • Layer of salt on crockery/glasses. • Increase the rinse aid dosage *. • Close the salt container lid properly*. • Change water hardness setting, if necessary add salt *. [. . . ] • Close the salt container lid properly*. • Change water hardness setting, if necessary add salt *. • Use suitable glasses. • not removable • Insufficient water softening, calcium deposits. • Cannot be washed in the Opaque glasses/ dishwasher. glasses not sparkling Rust on cutlery Identifying appliance faults • Not made of stainless steel. • Use suitable cutlery. • The START indicator lamp flashes. [. . . ]