User manual WHIRLPOOL HB M4 INSTRUCTION FOR USE

[. . . ] Table of contents 4 5 6 7 7 Technical Data Installation and electrical connection Environmental concerns IKEA GUARANTEE 8 9 10 1 1 Your safety and that of others is paramount. This manual and the appliance itself provide important safety warnings, to be read and observed at all times. This is the safety alert symbol, pertaining to safety, which alerts users to potential hazards to themselves and others. All safety messages are preceded by the safety alert symbol and the following terms: DANGER Indicates a hazardous situation which, if not avoided, will result in serious injury. [. . . ] 1 hour at maximum heat setting, the cooking zone switches off). ENGLISH 7 Maintenance and cleaning It is good practice to clean the hob after each use. Before any cleaning operation, wait for the hob to cool down completely. This will prevent the build-up of dirt and make cleaning easier. € Use a clean cloth, absorbent kitchen wipes and a mild washing up liquid or a specific glass ceramic cleaner. • Remove baked-on dirt with the supplied scraper tool and specific cleaning products. € Any food spills should be cleaned off before they dry. € Foods with high sugar content (toffee, fruit juice, jam, etc. ) that boil over while cooking, or spattered sugar stains must be immediately removed using a scraper. • Do not use abrasive products , bleach , oven-cleaner spray or pan scourers. The hob should be treated periodically with a proprietary brand of protective wax for glass-ceramic hobs. Important Periodically check for dust under the appliance, near the cooling air inlet or the outlet openings. Dust build-ups can hinder ventilation and cooling of the electronic module and impair proper operation of the hob. Problem The hob does not work Possible cause The internal temperature of electronic parts is too high Solution Wait for the hob to cool down before using it again The display shows a flashing Call the After-Sales Service and specify the error code letter “F” alternating with the numbers 1-2-3-4-5-9 Important In the event you are unable to turn the glassceramic hob off after using it, disconnect it immediately from the power supply. Cooling fan The hob is equipped with a cooling fan which runs according to the internal temperature. Should the temperature exceed a set level, the power supply to the cooking zones is automatically and gradually reduced. If necessary, the entire hob will be switched off automatically and the control buttons will be blocked until the temperature has returned below the safety level. eNGLISH 8 Before calling the After-Sales Service: 1. Check “Troubleshooting guide” to see if you can eliminate the problem yourself 2. Turn the hob on again to check if correct operation has been restored. If the problem persists, contact the Aftersales Service. Give the following information: • type of fault; • hob model; • service number (i. [. . . ] € Cases where no fault could be found during a technician’s visit. € Repairs not carried out by our appointed service providers and/or an authorized service contractual partner or where nonoriginal parts have been used. € Repairs caused by installation which is faulty or not according to specification. € The use of the appliance in a non-domestic environment i. [. . . ]