User manual WHIRLPOOL HDD7000/PR0 BK INSTALLATION

[. . . ] Select the drying programme required by turning the programme selector knob (for information, refer to programme table). Select the option required by pressing the corresponding button. The indicator lamp above the relevant button lights up to confirm your selection. A fast blinking led indicates a wrong selection is made (incompatible options). [. . . ] 2. 5 kg - X X X X X 100’ 85’ Special programme Cupboard dry Adjusted drying intensity for jeans to reach an homogenous drying results. 3 kg 3. 0 X X X X - X 120’ 105’ Airing Laundry is aired and refreshed for 30 minutes without heating. - - X X - - X - - Drying times Completes drying for min. 3-5 full size textiles (suitable for all fabrics). - X X X X - X * Test programme in accordance with EN 61121. 2 How to proceed if . . . Clean the filter at the end of every cycle. • • • • • • Open the door. Brush lint using a soft brush or your fingertips. Push the filter back into place. . . . you want to correctly care for and clean your dryer: Empty the water container at the end of each drying cycle. Clean the heat exchanger at least every month. (For further information see chapter “Heat Exchanger” in the Instructions for Use). • Pull the handle to remove the water container. • Replace the water container when empty by pushing it completely back in place. • Remove fibres in and around the water evacuation hole at least once per month. Drying takes too long / laundry is not dry enough. • Has the correct drying programme been selected?• Was the inserted laundry too wet (washing machine spin speed less than 1000 rpm)?• Is the lint filter dirty (filter indicator light on)?(for more information, refer to the instructions for use) • Is the room temperature too high?• Are the “ ” and “Anti-crease” “ ” indicator lamps lighting up?The drying cycle is complete and the laundry can be taken out. • If the drying result does not meet your expectation, select a more dry programme. • Is the plug properly inserted into the mains electricity socket?• Has a drying programme been selected?• Has the “Start (Pause)” button been pressed?• Has the start-delay option been selected?• • • • Is the lint filter clean?Has the water container been inserted correctly?Is the heat exchanger clean? . . . you want to check the dryer yourself first: (If your machine is not functioning correctly, please check the following points before phoning for the customer service – also refer to relevant chapter in the instructions for use) The dryer will not operate (after a power failure, always press the “Start (Pause)” button). Lint filter or water container indicator lamp on. Water droplets underneath the dryer. • Has the heat exchanger been inserted correctly? [. . . ] Each time the button is pressed, the start time is delayed by 1 hour. Then press the “Start (Pause)” button to confirm the final selection and to start the dryer. The delayed start indicator lamp flashes and the countdown counts down in 1-hour intervals. The countdown is indicated by the indicator lamp above the button flashing. [. . . ]