User manual WHIRLPOOL HV303 INSTALLATION

[. . . ] MODELS HV303 & HV363 DOWNDRAFT BLOWER SYSTEM WARNING READ AND SAVE THESE INSTRUCTIONS !INTENDED FOR DOMESTIC COOKING ONLY ! WARNING 1. SMOTHER FLAMES with a close-fitting lid, cookie sheet, or metal tray, then turn off the burner. If the flames do not go out immedi ately, EVACUATE AND CALL THE FIRE DEPARTMENT. [. . . ] Lay out and cut the cooktop cut-out far enough FORWARD so downdraft will fit behind it. Set cooktop in place and slide it as far forward as possible. Center and square it with edges of countertop. · · the position of the blower discharge needs to be moved so ductwork does not interfere with floor joists, plumbing or wiring below. it is necessary to rotate the blower discharge to the RIGHT or LEFT. Place the unit on its back on a table or work surface. DOWN DISCHARGE - MOVING BLOWER LEFT OR RIGHT NUTS CLAMP CHANNEL BLOWER SHEET METAL SCREW 3. Place the plastic template against the back flange of the cooktop and center it. Trace around template to mark the downdraft opening. Use supplied cover plate to close open space (if any). Tighten nuts to secure top of blower and use sheet metal screws through bottom flange to secure bottom of blower. BOTTOM FLANGE 5. Be careful not to chip edges of countertop. MOUNT THE UNIT MOUNTING SCREWS LEVELING BRACKET FLANGE FACING OUT LEFT OR RIGHT DISCHARGE BLOWER NUT CLAMP CHANNEL MOTOR PLUG SHEET METAL SCREW LEVELING BRACKET FLANGE FACING IN COVER PLATE 1. Carefully lift blower and disconnect motor plug if necessary. Reposition blower and RECONNECT MOTOR PLUG. Use supplied cover plate to close open space (if any). Replace clamp channels and use nuts to secure the blower in its new position. Use sheet metal screws through bottom flange to secure bottom of blower. 1. Extend leveling brackets to floor of cabinet so downdraft sits straight. (Note: Leveling brackets can be removed and re-attached in other positions. Bottom flange may have to face inward in tight cabinet installations. ) 2. Secure the downdraft to the countertop as follows: Hold the downdraft against the back of countertop cut-out and tightening the 2 mounting screws (one on each end of unit) on underside of countertop. Use a wood shim between screw and underside of granite countertops. 3 3. Screw leveling brackets to bottom of cabinet. Tighten screws holding leveling bracket to unit on each side. INSTALL DUCTWORK CAUTION - BEFORE CUTTING HOLE IN CABINET FOR DUCTWORK: Check for interference with floor joists, wall studs, electrical wiring or plumbing. WIRING DIAGRAM BLOWER 3-1/4" X 10" TO 6" RD. [. . . ] The cost of service or service call to: a. For products requiring ventilation, rigid metal ducting must be used. Instruct the user on the proper use of the product. Transport the appliance to and from the servicer. [. . . ]