User manual WHIRLPOOL KHGL 7510/B/01 INSTRUCTION FOR USE

[. . . ] - The use of two burners simultaneously with just one container such as a fish kettle. Important: Do not rest and/or drag the pan supports upside down on the hob as this could scratch it. Failure to comply with these recommendations could lead to your glass ceramic hob getting damaged or broken and the safety of your equipment being compromised. Burner wok semi fast auxiliary Pan diameter from 24 to 26 cm from 16 to 24 cm from 8 to 14 cm 5 Positioning the pan supports and Wok pan adapter To facilitate positioning of the pan supports on the hob, it is recommended to start by fitting the right side one (1). Right side pan support (1) Fit the right side pan support ensuring that the burners’ caps pins are correctly centred (recesses for the pins are provided on the underside of the pan support). [. . . ] • Do not let children play with the pan supports. The rubber feet on the underneath of the pan supports could be swallowed by small and cause serious injury or suffocation. • Before replacing the pan supports on the hob, please check that all the rubber feet are in place. • Each time you finish using the hob, always check that the control buttons are in the off position and shut off the tap to the gas mains or cylinder. • Do not obstruct the air vents at the back of the appliance in any way. 8 Safeguarding the environment Packing The packing material is 100% recyclable and is labelled with the recycling symbol . Please dispose of all packing responsibly and carefully. Product This appliance is marked according to the European Directive 2002/96/EC, Waste Electrical and Electronic Equipment (WEEE). By ensuring that this product is disposed of correctly, you will help prevent potentially negative consequences for the environment and human health. The symbol on the product, or on the documents accompanying this appliance indicates that this product should not be disposed of as household waste. Please dispose of this appliance at an Electrical & Electronic Equipment Collection point as in accordance with local environmental regulations for waste disposal. For details of your local Collection Point please contact your Local Authority. Conformity declaration This hob was designed, built and marketed in compliance with: • the safety requirements in the “Gas” CEE Directive 90/396. Important: if a stainless steel hose is used, it must be installed so as not to touch any mobile part of the furniture. It must pass through an area where there are no obstructions and where it is possible to inspect it on all its length. After connection to the gas supply, check for leaks with soapy water. Attention: Should you experience difficulty in turning the burners knobs, please contact the After Sales Service for the replacement of the burner tap. 10 Electrical connection The electrical connections must comply with current legislation and be carried out by a qualified, competent person. • Information on the voltage and power absorbed are shown on the serial no. • When installing the appliance, we recommend that this hob is protected by a 3mm bi-polar switch. • If damaged, the power cable must be replaced with an identical type of powercable ( H05V2V2-FT90 ºC, or H05RR-F type). We recommend that this operation be conducted by our After Sales Service. Please contact our Customer Care Centre on 00800-3810-4026. • The manufacturer declines all responsibility for damage to persons, pets or goods as a result of failure to comply with the regulations above. L Earth (yellow/green) N Installation 1. After cleaning the surfaces around the edges, fit the seal provided around the hob. [. . . ] all the parts on the burner are properly positioned. the button was pushed in properly when turning on the burner for the time required to activate the safety thermocouple. the burner’s openings are not blocked in relation to the thermocouple. the end part of the thermocouple is clean. [. . . ]