User manual WHIRLPOOL KRI 11211/1/A INSTRUCTION FOR USE

[. . . ] Scrapping/Disposal The appliance is manufactured using recyclable material. This appliance is marked in compliance with European Directive 2002/96/EC on Waste Electrical and Electronic Equipment (WEEE). By ensuring the correct disposal of this appliance, you can help prevent potentially negative consequences for the environment and the health of persons. [. . . ] • Only original spare parts supplied by the manufacturer should be used when replacing components in the ice and water dispenser. • Any work on the appliance must be carried out by a qualified technician or the After-sales Service. 6 PRECAUTIONS AND GENERAL RECOMMENDATIONS INSTALLATION • The appliance must be handled and installed by two or more persons. • Be careful not to damage the floors (e. g. • During installation, make sure the appliance does not damage the power cable. • Make sure the appliance is not near a heat source. • To guarantee adequate ventilation, leave a space on both sides and above the appliance and follow the installation instructions. • Keep the appliance ventilation openings free. • Do not damage the appliance refrigerant circuit pipes. • Install and level the appliance on a floor strong enough to take its weight and in a place suitable for its size and use. • Install the appliance in a dry and well-ventilated place. The appliance is arranged for operation in places where the temperature comes within the following ranges, according to the climatic class given on the rating plate. The appliance may not work properly if it is left for a long time at a temperature outside the specified range. (°F) From 10 to 32 From 50 to 90 From 16 to 32 From 61 to 90 From 16 to 38 From 61 to 100 From 16 to 43 From 61 to 110 SAFETY • Do not store explosive substances such as aerosol cans with a flammable propellant in this appliance. • Do not store or use petrol, flammable liquids or gas in the vicinity of this or other electrical appliances. The fumes can cause fires or explosions. • Do not use mechanical, electric or chemical means other than those recommended by the Manufacturer to speed up the defrost process. [. . . ] Fit replacement 13A fuse into fuse cover. Refit both into plug. Important: The fuse cover must be refitted when changing a fuse and if the fuse cover is lost the plug must not be used until a correct replacement is fitted. Correct replacement are identified by the colour insert or the colour embossed in words on the base of the plug. [. . . ]