User manual WHIRLPOOL KSDN 5061/A INSTRUCTION FOR USE

[. . . ] • The packaging box is recyclable and is marked with the recycling symbol . • The appliance is manufactured using recyclable material. When scrapping, follow the local disposal regulations for safeguarding the environment. To avoid the risk of children being trapped and therefore suffocating, do not allow them to play or hide inside the refrigerator. [. . . ] • If the dispenser does not dispense ice when you press the bar, change the ice selection from ice cubes to crushed ice or vice versa, (see figure) so as to remove any ice blocks. • If the dispenser still does not dispense ice, wait two minutes and repeat this operation. • If there is condensation in the ice/water dispenser area, press the corresponding button (marked A in the figure) to activate the anticondensation device. To dispense water: After the water dispenser has been switched on, throw the first glasses of water away, then the water can be used. Repeat this operation whenever water has not been dispensed for a long time. You do not need to apply a lot of pressure to the lever in order to activate the dispenser. Hold the edge of the glass close to the dispenser opening. Remove the glass slowly so water does not spill out of the glass. Pressing hard will not make the water dispenser operate faster or produce greater quantities. 37 4gb33015. fm Page 38 Wednesday, March 10, 2004 4:02 PM Use of the dispenser light and dispenser lock (on some models) The dispenser area has a night light. It can be turned on and off by pressing the button located at the centre of the panel. Your dispenser can be turned off for easy cleaning or to prevent accidental dispensing by small children and pets. To switch the dispenser off, press button until symbols turn off. To switch the dispenser on again, repeat the operation. The ice maker will automatically switch off when it finishes making ice. Throw old ice cubes away and make a new supply. Wait about 3 minutes for the dispenser motor to reset. Large amounts of ice should be taken from the bucket, not through the dispenser. Throw old ice away and make a new supply. Store excess ice in a covered container. Water containing minerals may require a filter. Follow instructions for a proper water supply to ice maker. THE ICE DISPENSER STOPS WORKING. The dispenser has not been used for extended periods, causing the ice cubes to melt together. The ice dispenser lever has been held in for too long. OFF-TASTE OR ODOUR TO ICE. Ice absorbs airborne odours. Water quality. Food not properly wrapped. The ice bucket and the freezer compartment may need cleaning. Plumbing connections to ice maker. The first few batches of ice from a new ice maker may have an off-taste. Throw the first few batches away and make a new supply. NOTE: Only use cubes from the ice maker. 40 4gb33015. fm Page 41 Wednesday, March 10, 2004 4:02 PM Maintenance and cleaning Before any cleaning or maintenance operation, unplug the appliance from the mains or disconnect the electrical power supply. Periodically clean the refrigerator and freezer compartments with a sponge dampened in a solution of lukewarm water and vinegar. Never clean refrigerator parts with flammable fluids. The fumes can create a fire hazard or explosion. [. . . ] When the light changes from green to yellow, this means that it is almost time to change the water filter cartridge (90% of the filter life has been used). The water filter cartridge should be replaced when the water filter indicator light changes to red. Or when water flow to your water dispenser or ice maker decreases noticeably (See “Changing a water filter cartridge” later in this section). Note: Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system. [. . . ]