User manual WHIRLPOOL KVIE 3160 A LH PRODUCT FICHE

[. . . ] ACCESSORY Child guard AMH 122 This accessory can be obtained from the After Sales Service under code number 4819 310 18436 or from your dealer under reference number 017124. € • • To use the hob, turn the knob(s) clockwise and set it/them to the required power. To turn the hob off, turn the knob(s) back to position “0”. The hob is fitted with residual heat indicators. [. . . ] With little water in order to cut down cooking time. A pressure cooker allows you to save even more energy and time. DIMENSIONS OF THE COOKTOP AND WORKTOP (mm) Make sure that the voltage indicated on the rating plate is the same as the mains voltage. Technical data is given on the rating plate on the edge of the hob and also below: Telescopic knobs (depending on model) • • The knobs can be lifted approx. After cleaning, restore the knob to its original position. CAUTION • • • • Type PLEVS 230V- 50Hz 5, 3 Kw 5019 319 62057 • Should the hob become cracked or broken, do not use TROUBLESHOOTING GUIDE it and call the After Sales Service immediately. The hob does not work: If the hob incorporates halogen cooking elements, do - Make sure that the power supply is on. - Turn the hob off and on again, to make sure that the The hob is designed for use as a domestic food cooker problem has been solved. The Manufacturer - Make sure that the knob is not turned to “0”. Declines all responsibility for inappropriate use or Turn the multi-pole switch to “Off” for a few minutes incorrect setting of the controls. And then turn it back to “On”. INSTALLATION Recommendations Important: Disconnect the hob from the mains before carrying out any installation work or servicing. € All electrical connections must be made before connecting the appliance to the power supply. € Installation must be carried out by a qualified technician in accordance with the manufacturer's instructions and in compliance with local regulations. € Unpack the hob and make sure that the appliance has not been damaged during transport. If you are not sure contact the dealer or the nearest service centre. Preparing the housing unit Cut the worktop to fit before installing the appliance. Carefully remove any shavings or sawdust that could prevent the appliance from running properly. Attention: to install the hob on other surfaces than wood (marble, plastic, ceramic, marble, stone, etc. ) remember to ask After Sales Service for the fixing plates (fig. € The hob must be fitted in a worktop with a minimum thickness of 20 mm and a maximum of 50 mm. € Insert a separator panel at a minimum distance of 90 mm from the bottom of the hob, so that it cannot be accessed by the user. [. . . ] The installer is responsible for connecting appliances correctly to the mains and for observing the safety regulations. The oven power cable must be long enough to connect the built-in appliance to the mains. Observance of safety directives requires that a multipole switch with a minimum contact gap of 3 mm be used for the installation. do not use multiple plug adapters or extension leads. [. . . ]