User manual WHIRLPOOL LOE 1207 PRODUCT FICHE

[. . . ] Remove the transport bolts • The washing machine is fitted with a transport bolts to avoid any possible damage to the interior during transport. Before using the washing machine, it is imperative that the transport bolts are removed 3. • • • Install the washing machine Remove the protective foil from the control panel Move the appliance without lifting it by the worktop Install the appliance on a solid and level floor surface, preferably in a corner of the room • Make sure that all four feet are resting firmly on the floor and check that the appliance is perfectly level (use a spirit level) 4. Water inlet • Connect the water supply inlet hose in accordance with regulations of your local water company • Water inlet: • Tap: • Water pressure (flow pressure): Cold water only 3/4 threaded hose connection 100-1000 kPa (1-10 bar) 6. [. . . ] • Do not use any solvents in the washing machine (e. • If you use starch powder, proceed as follows: 1. Wash your laundry using the desired wash programme. Then stir the starch in with water in a beaker. Select the “Rinse and Spin” programme, reduce the speed to 800 rpm and start the programme. Pull out the detergent drawer until you can see about 3 cm. of chamber while the water is running into the detergent drawer. Pour the starch solution into chamber 6. If there are starch residues in the detergent drawer when the programme has finished, clean it if necessary (see “Cleaning and Maintenance”). Take note also of the starch manufacturer's information. 21 5GB10074. fm Page 22 Wednesday, June 23, 2004 12:01 PM REMOVING THE FILTER We recommend that you check and clean the filter regularly, at least two or three times a year. Especially: • When the appliance does not drain or spin properly • If the pump is blocked by a foreign body (e. g. buttons, coins or safety pins) IMPORTANT: make sure the water has had time to cool before draining the appliance. Remove the inserts (the siphon from the softener compartment and the coloured insert for liquid detergent). Replace the parts and refit the detergent dispenser. Insert the detergent dispenser in the washing machine. Mesh Filters in the Water Connection Check and clean regularly. For washing machines with a straight inlet hose 1. Turn off the tap and unscrew the water inlet hose from the tap. Clean the internal mesh filter and screw the water inlet hose back onto the tap. Reselect the desired programme and press the “Start” or “Start/Pause” button • the door has not been closed before pressing the “Start” or “Start/Pause” button. Open and close the door again and press the “Start” or “Start/Pause” button. • the “On/Off” button has been pressed and the light is on • the washing machine safety system has been activated (see “Fault Indicators” table) Detergent and additive product residues in dispenser at end of wash. Check whether: • the siphon is correctly installed and clean (see “Care And Maintenance”) • sufficient water is entering. The mesh filters in the water connection could be blocked (see “Care And Maintenance”) • when using powder detergent beforehand the coloured insert for dosing liquid detergent has been removed from the dispenser The washing machine vibrates during the spin cycle. [. . . ] First of all select and start the “Drain” cycle. Then select and start the desired programme again. For models with no fault display, the washing machine stops in the appropriate programme step. First switch the washing machine off and on again to continue with the programme. If the fault persists, please contact After-Sales Service (see “After-Sales Service”). [. . . ]