User manual WHIRLPOOL MAXY 100 BLUE PROGRAM CHART

[. . . ] Use Stain Treat option for optimal removal of organic stains like blood, egg yolk etc. For no-iron fabrics such as sport shirts, permanent press blends, cotton and linens. For slightly soiled overalls and sports wear made of cotton, polyester, polyamide and blends with cotton. For curtains, delicate dresses, skirts, shirts and blouses. [. . . ] • The time delay indication disappears when the programme starts and it is replaced by the remaining time. • The number of hours preselected can later be reduced pressing again the “Start Delay” button. To cancel the “Start Delay”. • Press the “Pause/Cancel” button once. • Press the “Start Delay” button up to 00 h in the display. • Check the programme setting and press and hold the “Start” button. ADD DETERGENT, CLOSE THE DOOR AND SELECT THE PROGRAMME Add the detergent as described in the programme table or in the chapter “Detergent and Additives” of the instructions for use. The remaining time display shows the duration of the chosen programme (in hours and minutes) and the pilot lamp of the wash cycle button lights up. The programme sequence, the predefined spin speed, water temperature, End of Cycle signal and options indicators corresponding to the selected programme light up. The recommendations can be altered by pressing the modifier and the option buttons. SELECT ANY DESIRED OPTION AND MODIFIER Selecting any option the indication lights up. When the combination of programme, additional options and modifiers is not possible, the indication lights switch off automatically and a signal sounds. “Prewash” • For heavily soiled laundry. • Add detergent to the Prewash and Main Wash dispenser compartments. • When using the Prewash compartment, do not use liquid detergent in the Main Wash compartment: use powder detergent for the main wash cycle. • “Prewash” and “Auto Soak” options cannot be selected in the same cycle. “Stain Treat” • For heavily soiled laundry. • Warm water fill for optimal organic soil removal and heat to high temperature. “Auto Soak” • For heavily soiled laundry with set-in stains. • Use with a wash cycle: Select the desired wash cycle and “Auto Soak” option, add detergent to the Prewash and the Main Wash dispenser compartments; press the “Start” button. When using the Prewash compartment, do not use liquid detergent in the Main Wash compartment: use powder detergent for the main wash cycle. • Use without a wash cycle: Select first “Drain/Spin” or “Rinse/Spin” and then “Auto Soak” option; choose the desired soak temperature, add detergent to the Prewash compartment and press the “Start” button. • “Prewash” and “Auto Soak” options cannot be selected in the same cycle. “2nd Rinse” • This option is recommended to ensure the removal of detergent or bleach residues from garments. • It provides an additional rinse with the same water temperature as the first rinse. CHANGE THE PROGRAMME, TEMPERATURE, OPTIONS AFTER PROGRAMME START 1. [. . . ] Fix the Y-piece connector to the cold fill tap. Connect the two inlet valves present on the rear part of the machine to the Y-piece connector using the relative provider hoses. Make sure: All connections are tightly fixed. Cold fill Y-piece Cold fill Hot fill If you wish to connect hot and cold water supply (Fig. Fix the red marked inlet hose at the hot water tap and at the inlet valve with the red filter on the rear side of machine. [. . . ]