User manual WHIRLPOOL MGC 3020 AAS INSTRUCTION FOR USE

[. . . ] 0 • - PRATICAL ADVICE FOR USING THE BURNERS For better burner performance, please stick to the following rules: Use pots and pans that fit the burners (see table on the right). Use the correct amount of water for cooking foods and keep the pot covered. Burner rapid semi-rapid Pot Ø from 24 to 26 cm from 16 to 22 cm ELECTRIC SUPPLY: 230 -240 V - 50 Hz 5019 919 01000 To get full satisfaction from the hob, please read these instructions carefully and keep them for future consultation. PRECAUTIONS AND GENERAL ADVICE To get full satisfaction from your hob, please read these instructions carefully and keep them for future consultation PROTECTING THE ENVIRONMENT 1. [. . . ] 2 of AS5601 to a height of not less than 150mm above the hotplate top surface for the full length and width of the cooking surface area. Note: the cooking surface area is defined as the part of the appliance where the cooking normally takes place and does not include those parts of the appliance containing the control knobs. ELECTRICAL CONNECTION • • • The electrical connections must comply with local regulations. The data relevant to the voltage and power absorption are indicated on the rating plate. The earthing of this appliance is compulsory by law. Check the “gas type” sticker attached to the hotplate. Details of the injector sizes used are recorded on the data plate located on the base of the appliance. This appliance shall be installed in accordance with installation requirements of the local gas authority to the appropriate installation code (AS5601). Before installing the hotplate consider the location of the gas supply and routing the gas line. For ULPG models the gas supply for the hotplate must be regulated to a pressure of 2. For NG models the gas supply is connected to a regulator which is supplied. A manual shut-off valve must be installed in the gas line, in an accessible position external to the hotplate, so that in the event of an emergency or service, the gas supply can be shutoff. After installing the gas supply and making all connections check thoroughly for possible leaks. Turn all control knobs on the unit to “OFF” position. Using a soap and water solution check each gas connection one at a time, by brushing the solution over connection. presence of bubbles will indicate a leak. Tighten the fitting and re-check for leaks. If it is not possible to correct the leak, replace fitting. Under no circumstance use matches or flame for checking leaks. Turn on appliance gas cock and light each burner. Check for a clear blue flame without yellow tipping. If burners shows any abnormalties check the following: Burner cap on correctly Burner positioned correctly Burner vertically aligned with injector nipple In some cases the burners will fail to ignite immediately and will seem to 'blow's lightly when they do ignite, this is usually due to air in the gas pipe which should clear itself within seconds of operation. [. . . ] If any repairs are required, please contact an authorised After-Sales Service, as indicated in the warranty. Note: Failure to comply with these instructions may compromise the safety and quality of the product. Customer Service: 1300 363 344 Service Call Booking: 1300 361 166 CARE AND MAINTENANCE CLEANING THE HOB SURFACE • • To maintain your hob in perfect conditions, clean it after every use, removing any food spills. Before any cleaning operation, disconnect the hob from the mains and wait for it to cool down. [. . . ]