User manual WHIRLPOOL MT 66/WH INSTRUCTION FOR USE

[. . . ] Changing programme selection: If the programme selected is changed during drying, the dryer stops. the “Départ (Pause)” indicator lamp flashes. To operate the new programme, again press the “Départ (Pause)” button. Interrupting programme: To interrupt a drying cycle, press the “Départ (Pause)” button and open the door. [. . . ] Cleaning the lint filter: Open door, pull lint filter up and out of machine and open it. Brush lint using a soft brush or your fingertips. Close lint filter and push firmly back into place. Emptying water container: Pull container out by the handle and empty. Replace the container when empty by pushing it completely back into place. If required, activate child safety lock (additional information can be found in the “Door Reversibility/Child Safety Lock” chapter of the instructions for use). Switching dryer off Please note: Only use additives/plastic items specified as dryer safe and rinse items that have been treated with stain remover thoroughly in plenty of water before drying. Never dry rubber objects or objects stained with vegetable oils in the dryer. 1 Overview of programmes Type of textile Programmes / Drying levels Ready to wear Fabrics Volume of load kg Gentle Options Buzzer Start delay Approximate drying times (in minutes) Very wet load Wet load Multi-layered, thick laundry such as: terry towels, dish cloths and dry towels, bed linen, underwear, terry towelling bath robes. Similar types of laundry which do not require Cotton Cotton or linen hot wash / coloured laundry 3. 0 X X X X X X X X X X X X X X X X X X 95’ 80’ 205’ 170’ 80’ 60’ 150’ 120’ 60’ 50’ 125’ 100’ 45’ 100’ 25’ 70’ 20’ 60’ 40’ 80’ 20’ 55’ 15’ 40’ Cupboard dry * ironing such as: dry towels, bed linen, underwear, baby clothes, T-shirts, cotton socks. The drying cycle is complete and the laundry can be taken out. € If the drying result does not meet your expectation, select a more dry programme. € Is the plug properly inserted into the mains electricity socket?€ Has any fluff on the heat exchanger seal been wiped away?€ Has any fluff on the door seal been wiped away? • Has the water container been inserted correctly?AFTER-SALES SERVICE If the fault is still present once the above checks have been undertaken or should the fault occur for a second time, switch the machine off. Please contact your after-sales service representative (for more information, refer to the warranty manual). Please have the following details ready when calling your After-Sales service representative: • The nature of the fault. € The service code (the number after the word Service on the adhesive rating plate) on the right-hand side when the door is open. 3 Before using the machine, please also read the instructions for use carefully! [. . . ] Empty the container and restart the drying programme. Empty the water container after every drying cycle. buzzer Signals/sounds end of drying cycle. Clean heat exchanger The Led lights up after 30 cycles when the heat exchanger needs to be cleaned. [. . . ]