User manual WHIRLPOOL OV A01 S INSTRUCTION FOR USE

[. . . ] FRAMTID OV3 GB DE FR IT ENGLISH DEUTSCH FRANÇAIS ITALIANO 4 20 37 60 ENGLISH 4 Safety information Product description Control panel Daily use Cooking tables Cleaning and maintenance Table of contents Your safety and that of others are very important This manual and the appliance itself provide important safety warnings, to be read and observed at all times. This is the danger symbol, pertaining to safety, which alerts users to potential risks to themselves and others. All safety warnings are preceded by the danger symbol and the following terms: DANGER!Indicates a hazardous situation which, if not avoided, will cause serious injury. [. . . ] When the oven is cold, dry the inside of the door with a cloth or sponge. Accessories • Soak the accessories in water with washing up detergent immediately after use, handling them with oven gloves if still hot. € Food residues can be easily removed using a brush or sponge. Cleaning the rear wall and catalytic side panels of the oven (if present): IMPORTANT: do not use corrosive or i abrasive detergents, coarse brushes, pot scourers or oven sprays which could damage the catalytic surface and ruin its self-cleaning properties. € Operate the oven empty with the fan assisted function at 200°C for about one hour. € Next, leave the appliance to cool down before removing any food residue with a sponge. -- Ensure the oven is cold before carrying out the following operations. -- Disconnect the oven from the power supply. Lift the catches and push them forwards as far as they will go (Fig. Close the door as far as it will go (A), lift it up (B) and turn it (C) until it is released (D) (Fig. Close the door To replace the rear lamp 1. Disconnect the oven from the power supply. 5), replace the lamp (see note for lamp type) and screw the lamp cover back on. NOTE: Only use 25-40W/230V type E-14, T300°C incandescent lamps. Lamps are available from IKEA After Sales Service. The oven is not connected to the electrical supply. ‘The oven selector is turned to “0”. The oven selector is turned to “ ”. The door is locked and will not release. The electronic programmer does not work. Turn off the oven and restart it to see if the fault persists. If the electronic programmer (depending on the model) presents the message “F HH”, contact the nearest After Sales Service. [. . . ] € Cases where no fault could be found during a technician’s visit. € Repairs not carried out by our appointed service providers and/or an authorized service contractual partner or where nonoriginal parts have been used. € Repairs caused by installation which is faulty or not according to specification. € The use of the appliance in a non-domestic environment i. [. . . ]