User manual WHIRLPOOL OV B32 S INSTRUCTION FOR USE

[. . . ] Technical data Installation Electrical connection Environmental concerns IKEA GUARANTE 16 18 19 21 21 22 Your safety and that of others are very important This manual and the appliance itself provide important safety warnings, to be read and observed at all times. This is the danger symbol, pertaining to safety, which alerts users to potential risks to themselves and others. All safety warnings are preceded by the danger symbol and the following terms: DANGER!Indicates a hazardous situation which, if not avoided, will cause serious injury. [. . . ] ) condensation may form on the inside of the door and around the seal. When the oven is cold, dry the inside of the door with a cloth or sponge. Accessories • Soak the accessories in water with washing up detergent immediately after use, handling them with oven gloves if still hot. € Food residues can be easily removed using a brush or sponge. Cleaning the rear wall and catalytic side panels of the oven (if present): IMPORTANT: do not use corrosive or i abrasive detergents, coarse brushes, pot scourers or oven sprays which could damage the catalytic surface and ruin its self-cleaning properties. € Operate the oven empty with the forced air function at 200°C for about one hour. € Next, leave the appliance to cool down before removing any food residue with a sponge. cleaning cycle of ovens with Pyrolytic function (if present): WARNING!€ Do not touch the oven during the pyrolysis cycle. € Keep children away from the oven during the pyrolysis cycle. This function burns off spatters produced inside the oven during cooking at a temperature of approx. At this high temperature, the deposits turn into a light ash which can be easily wiped away with a damp cloth, when the oven is cool. Do not select the pyrolysis function after every use, only when the oven is very dirty or produces smoke or fumes while preheating or cooking. € If the oven is installed below a hob, make sure that all burners or electric hotplates are switched off during the self-cleaning (pyrolysis) function. electrical malfunction due to voltage fluctuations. For Framtid OV5 -- Set the function selector knob to “0”. -- Set the timer to 5 min and wait for the oven door to be released. For Datid OV7 -- Set the function selector knob to F . -- Set the clock to (see “Control panel”) Wait 2 minutes for the door to be released. The electronic programmer does not work (Nutid and Framtid OV9 version) Electrical malfunction due to voltage fluctuations. If the electronic programmer (depending on the model) shows “F HH”, contact the nearest AfterSales Service Specify in this case the number that follows the letter “F”. Energy consumption with a standard load and pastry function Kwh ENGLISH 17 Before calling the After-Sales Service: 1. [. . . ] € Cases where no fault could be found during a technician’s visit. € Repairs not carried out by our appointed service providers and/or an authorized service contractual partner or where nonoriginal parts have been used. € Repairs caused by installation which is faulty or not according to specification. € The use of the appliance in a non-domestic environment i. [. . . ]