User manual WHIRLPOOL SRA20X INSTRUCTION FOR USE

[. . . ] slightly to normally soiled blouses , shirts , overalls etc. Made of polyester (Diolen, Trevira), polyamide (Perlon, Nylon) or blends with cotton. curtains and delicate clothing , dresses , skirts , shirts and blouses. Only woollens with a felt-free finish, labelled with the woolmark and identified as machine washable. [. . . ] Only woollens with a felt-free finish, labelled with the woolmark and identified as machine washable. If you select “Rinse Hold” do not leave items to soak for too long. textiles made of silk , linen , wool and viscose marked as “handwashable”. If you select “Rinse Hold” do not leave items to soak for too long. Same as the last two rinses and the final spin in the "Synthetic" programme. Programme for treating wash with starch or softener. Same as the last rinse and the final spin in the “Cotton” programme. Programme for treating wash with starch or softener. in this programme spinning is intensive. Same as the spin cycle in the “Cotton” programme. The data on the “Energy Label” refer to the programme “Cotton 60°C”. * To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains the water out. Load the machine, close the drum flaps and check that they are properly locked. Add detergents and additives into the dispenser to no more then the “MAX“ level mark, as follows: • Programme with pre and main wash • Main wash programme without prewash • Fabric softeners and conditioners • Chlorine bleach • Stain remover agents • Anti-scale agents (if necessary) 3. Turn the programme selector knob to the desired programme. Turn the temperature selector knob to the desired temperature. Turn the spin speed selector knob to the desired spin speed. If the spin speed “0” is selected, the final spin is cancelled, but not the intermediate spins. SELECT THE DESIRED OPTION Selecting or deselecting an option can be done at any time during the programme. The option will be applied as long as the corresponding programme phase has not been executed yet. [. . . ] If the spin speed “0” is selected, the final spin is cancelled, but not the intermediate spins. SELECT THE DESIRED OPTION Selecting or deselecting an option can be done at any time during the programme. The option will be applied as long as the corresponding programme phase has not been executed yet. “Intensive Rinse” button • One rinse cycle is added to ensure a more intensive rinse. [. . . ]