User manual WHIRLPOOL TT 162 PRODUCT FICHE

[. . . ] • The appliance must be connected exclusively by means of a socket with an earth connection in accordance with current regulations. The manufacturer declines all liability for damage to persons or property deriving directly or indirectly from failure to observe the directions. • Do not use extension leads or multi sockets. • Before any maintenance on the washing machine disconnect it from the mains supply. [. . . ] If you notice this problem, shake or brush the affected items or use a liquid detergents. Keep detergents and additives in a dry place and out of reach of children. Use only detergents and additives specifically produced for domestic washing machines. If you use descaling agents, dyes or bleaches, make sure they are suitable for washing machine use. Descaler could contain components that can attack parts of your washing machine. Do not use solvents (turpentine, benzine, etc. ). Do not machine wash fabrics that have been treated with solvents or flammable liquids. Dosage Follow the instructions on the detergent pack in relation to: • the degree and type of soiling; • the size of the load; - full load: follow the detergent manufacturer’s instructions; - half load: 3/4 the amount used for a full load; - minimum load (about 1 kg): half the amount used for a full load; • water hardness in your area (ask for information from your water company): soft water requires less detergent than hard water. Notes: Too much detergent can result in excess foam formation, and the reduction of washing efficiency. If the appliance detects excessive foam it may prevent spinning. Insufficient detergent may result in: grey laundry, deposits on the drum, tub and heater. When using concentrated fabric softeners, add water in the detergents dispenser up to “MAX” level mark. It is best in this case to drain the machine after every wash. 2. Turn off the tap, disconnect the water supply hose from the machine and allow the water to drain into a basin. 3. Open the foreign body trap, let the water drain into a small shallow basin and close the trap. Close the drum flaps turn the drum a half-turn. Using a spanner, press on the plastic tip while sliding the blade from left to right. Open the drum: you can recover the object through the hole in the drum. Refit the blade from inside the drum: Position the plastic tip above the hole on the right side of the drum. Then slide the plastic blade from right to left until it clips. Close the drum flaps again, turn the drum through half a turn and check if all 6 hooks of the lifter is properly anchored into the drum. Plug the appliance in again. 3 4 4 7 70 3gb00028. fm5 Page 71 Wednesday, April 4, 2001 7:02 PM Appliance exterior and control panel • Clean using normal household cleaner (do not use abrasive products or paint-thinners). • Wipe with a soft cloth. Lid seal • Clean from time to time with a damp cloth. Water inlet hose(s) • Check the hose regularly for brittleness and cracks. [. . . ] • The inlet hose and the plastic enclosure contain electrical components: Do not cut the hose and do not immerse the enclosure in water. • If the flexible hose is damaged, unplug the appliance from the mains immediately and replace it. If the flexible hose is too short, replace it with a 3 m Water Stop hose (available from After-Sales Service or from your dealer). This operation must be carried out exclusively by a qualified technician. Connect the water drain hose 1. Unhook the drain hose from the left and right hose connections, see arrow A in figure. [. . . ]