User manual WHIRLPOOL UXT4030ADS INSTALLATION GUIDE

[. . . ] 4 CM) RANGE HOOD Installation Instructions and Use & Care Guide For questions about features, operation/performance, parts, accessories or service, call: 1-800-253-1301 or visit our website at www. Com In Canada, call 1-800-807-6777 or visit our website at www. RANGE HOOD SAFETY Your safety and the safety of others are very important. We have provided many important safety messages in this manual and on your appliance. [. . . ] Prepare Range Hood Align the exterior edge of the mounting brackets with the exterior edges of the upper cabinet. IMPORTANT: The brackets should touch the upper cabinet. With a pencil, mark the upper holes on the brackets. –  ■ Set the range hood on its back on a covered surface. Using a #2 Phillips screwdriver, remove the electrical box cover. Using a flat-blade screwdriver, remove the appropriate power supply knockout. Drill Electrical Opening Lift the range hood into place and insert the mounting bracket tabs through the slots in the back of the range hood. Using a 1¹⁄₄" (3 cm) drill bit, drill the hole in the dot marked previously at the electrical strain relief. OPTIONAL: Using a ¹⁄₈" (3 mm) drill bit, drill pilot holes for the dots marked previously at each mounting tab at an approximate 45° angle in an upward direction. Prepare Range Hood Vents and Mounting Tabs x2 90˚ C B B A Hold the range hood firmly in place with one hand and bend each mounting tab (A) upward approximately 90°. Mark the hole at the power supply knockout (B). OPTIONAL: Mark the hole in each mounting tab. 2 x 16 mm) truss-head screw into the mounting tab (C) on each side of the range hood as shown in the inset. Insert the screws approximately 2 turns into the mounting tab holes. –  ■ Non-vent (Recirculating) Installations Remove the (2) T10®† Torx® screws and remove the top, front rectangular vent cover (B). Mount Range Hood ■ Option 1 - Direct Wire Installations Use a UL Listed/CSA Approved wire connector and connect the 2 white wires (A) together. Use a UL Listed/CSA Approved wire connector and connect the 2 black wires (B) together. –  Lift the range hood into place, positioning the rear slots over the mounting brackets. Using a Phillips screwdriver, push on the screws that are started into the top mounting tabs and bend the tabs against the cabinet side walls. Attach the screws to the cabinet side walls. IMPORTANT: Do not overtighten the screws. For direct wire installations, run the home power supply cable according to the National Electric Code or CSA standards and local codes and ordinances. [. . . ] This limited warranty is effective from the date of original consumer purchase. Proof of original purchase date is required to obtain service under this limited warranty. Commercial, non-residential, multiple-family use, or use inconsistent with published user, operator or installation instructions. In-home instruction on how to use your product. [. . . ]