User manual WHIRLPOOL UXT4136ADS USE & CARE GUIDE

[. . . ] 4 CM) RANGE HOOD Installation Instructions and Use & Care Guide For questions about features, operation/performance, parts, accessories or service, call: 1-800-253-1301 or visit our website at www. Com In Canada, call 1-800-807-6777 or visit our website at www. RANGE HOOD SAFETY Your safety and the safety of others are very important. We have provided many important safety messages in this manual and on your appliance. [. . . ] Replace all parts and panels before operating. Failure to do so can result in death or electrical shock. –  NOTE: For installations to a surface other than drywall, it is recommended that a qualified contractor determine the anchoring method. Prepare Range Hood Align the exterior edge of the mounting brackets with the exterior edges of the upper cabinet. IMPORTANT: The brackets should touch the upper cabinet. With a pencil, mark the upper holes on the brackets. –  ■ Set the range hood on its back on a covered surface. Using a #2 Phillips screwdriver, remove the rectangular damper attached with 3. Using a #2 Phillips screwdriver, remove the electrical box cover. Using a flat-blade screwdriver, remove the appropriate power supply knockout. 4 cm) Rectangular Vent System Lift the range hood into place and insert the mounting bracket tabs through the slots in the back of the range hood. –  45˚+ 90˚ A A Using a ¹⁄₂" (13 mm) drill bit, drill a hole in each of the dots marked previously on either the wall or upper cabinet. Using the outside edges of the holes, mark the vent opening. Using a jigsaw or keyhole saw, cut the vent opening. Drill Electrical Opening C C B D D Hold the range hood firmly in place with one hand and bend each mounting tab (A) upward approximately 90°. Mark the hole at the power supply knockout (B). for a non-vented (recirculating) installation: Go to Step 7. For a top vented installation: Mark the 4 vent hole locations (C) on the top of the range hood. For a rear vented installation: Mark the 4 vent hole locations (D) on the rear of the range hood. OPTIONAL: Mark the hole in each mounting tab. remove the range hood and set it aside. Using a 1¹⁄₄" (3 cm) drill bit, drill the hole in the dot marked previously at the electrical strain relief. [. . . ] In the event of product replacement, your appliance will be warranted for the remaining term of the original unit's warranty period. This limited warranty is valid only in the United States or Canada and applies only when the major appliance is used in the country in which it was purchased. This limited warranty is effective from the date of original consumer purchase. Proof of original purchase date is required to obtain service under this limited warranty. [. . . ]