User manual WHIRLPOOL W8TXNGZBB USE & CARE GUIDE

[. . . ] U-Line products are making life more convenient in homes, businesses, and hotels around the world. U-Line supports its products with a strong dealer network, and its commitment to quality even extends to environmentally safe packaging. IMPORTANT READ all of the instructions in this guide completely before operating the unit for the first time. For future reference, keep this guide in a safe, accessible location. If you need additional information or assistance, please contact U-Line Corporation directly. [. . . ] Stainless Steel Models: · Stainless steel surfaces and components can discolor when exposed to chlorine gas, pool chemicals, salt water or cleaners with bleach. · Keep your stainless steel unit looking new by cleaning with a good quality all-in-one stainless steel cleaner/ polish on a monthly basis. For best results use Claire® Stainless Steel Polish and Cleaner, which can be purchased from U-Line Corporation (P/N 173348). Frequent cleaning will remove surface contamination that could lead to rust. Some installations may require cleaning on a weekly basis. · Do not clean with steel wool pads. · Do not use cleaners that are not specifically intended for stainless steel on stainless steel surfaces (this includes glass, tile and counter cleaners). · If any surface discoloring or rusting appears, clean it quickly with Bon-Ami® or Barkeepers Friend Cleanser® and a non-abrasive cloth. Always clean in the direction of the grain. Always finish this process with Claire Stainless Steel Polish and Cleaner or comparable product to prevent further problems. · Using abrasive pads such as ScotchbriteTM will cause the graining in the stainless steel to become blurred. To remove and replace the grille for access to the condenser fins, follow this procedure: ULIN_0193_A Figure 10 1. Use a level to check the levelness of the unit from front to back and from side to side. Level should be placed along top edge and side edge as shown (Figure 10). 1 2 Figure 9 ULIN_0203_A 1 Figure 11 1. Disconnect electrical power to the unit. Loosen two screws (Figure 9, 1) completely. NOTE: Screws are held in the grille by o-ring retainers, and will not come free of the grille. If the unit is not level, adjust the feet on the corners of the unit as necessary (Figure 11). Check the levelness after each adjustment and repeat the previous steps until the unit is level. WARNING DO NOT touch the condenser fins. The condenser fins are SHARP and can be easily damaged. 2115R, 2175R 11 Door Alignment Check and Adjustment IMPORTANT When properly aligned: · The door will not be flush with the top of the cabinet. The top edge of the door will be 1/8 in. · The door gasket will be firmly in contact with the perimeter of the cabinet and not pinched on the hinge side of the door. [. . . ] Blackout will end in 36 hours. View Actual Temperature (T1) Change °F-°C Blackout Mode Hold 5 seconds Release when °F flashes. Hold Hold 10 seconds Glass Door Models Task Touch Touch Display Comment Light normally goes on/off with door opening. Pressing light button will turn interior light on for 4 hours, then it will turn off. Hold Display off when door is closed (unless cabinet light is switched on). Repeat to switch back. Cabinet Light Display Off Mode All Ice Makers Task Touch Touch Display Comment Ice Maker Off Mode Hold Repeat to switch back Clear Ice & Clear Combo Only Task Clean Cycle Ice Thickness Adjustment Temporary Shutdown (Office Mode) Touch Hold Touch Display Comment Will automatically return to ice production when clean cycle is complete. [. . . ]