User manual WHIRLPOOL W8TXNWFBB ENERGY GUIDE

[. . . ] 2115WCOL units are shipped with a cardboard-wrapped door and an additional package of hardware. Complete and mail the Product Registration Card or register online at www. U-LineService. com. Once your unit is installed, keep the Use and Care Guide and this Installation Guide in a safe place for future reference. 2115WC units are Black, White or Stainless Steel. [. . . ] If staining the trim is desired, it must be done before the application of any type of final finish. Review the following staining/final finish and final finish-only guidelines when staining/ and or sealing the wood to ensure proper adhesion and durability of the finish. Stain may look darker when door is closed. Staining and final finish application: 1. Remove all screws securing wood trim to interior components, and remove the trim from the cabinet interior. NOTE: Your model will contain an electronic display panel in the lowest level trim piece. After removing the trim screws, and gently pulling the trim from its location, a wiring harness connector will become visible. Unplug the connector, and remove the trim from the interior. IMPORTANT DO NOT use oil-based stains on wood trim. Vapors from oil-based stains will permanently penetrate the liner and will not dissipate over time. www. U-LineService. com 8 06/2006 2115WC/2115WCOL Wine Captain® Overlay Frame (2115WCOL Units Only) 2. Typical routing dimensions are shown in Figure 14. 3/4" Frame Preparation An overlay frame covers the door frame to give a built-in appearance. Appropriate hardware and a copy of these instructions will be included in the unit. 1-1/8" 1-13/16" 2-1/4" 11/16" (Ref. ) 7/16" (Ref. ) IMPORTANT The thickness of the wood overlay frame must be 3/4". Cut foam tape into four pieces, two pieces the width of the overlay frame and two pieces the height of the overlay frame. Remove the adhesive protection strip from one piece of the foam tape and align to the edge of the overlay frame as shown in Figure 18, adhering the foam tape to the overlay frame. Trim each piece of tape immediately after application. Do not allow any overlapping of the foam tape. Damage to the overlay frame can occur if the foam tape is not trimmed properly. CAUTION It is important to ensure that all drilled holes are drilled to the correct depth in order to avoid splits in the wood when hardware is installed. Installation Instructions Preparing Door Gasket Note: Door is not attached. It is in a separate box inside the unit box and taped to the unit. Lay door on a clean, flat surface with the gasket facing up. Door 2. Pull gasket completely out of the groove. Start in the Figure 16 middle and pull outward, moving toward the edge (see Figure 16). This may take some force. Typical Wood Frame Top Pivot Plate 8 mm Plug Insert Two Required #6 X 5/8" Flat Head Screw Two Required Note: Lay gasket flat on a clean surface to avoid disturbing interior magnet. Checking Overlay Fit Figure 19 Attaching the Overlay Frame 1. [. . . ] Check the door, sides and top for a proper fit. Also test to make sure the door opens and closes freely. Remove grill and place a mark on the floor at the front of the unit. Also place a mark on the floor in the center of the unit. [. . . ]