User manual WHIRLPOOL WA UNIQ 834 BW PRODUCT FICHE

[. . . ] Unscrew the four screws (see arrows) with the wrench C supplied. Move the screws to the centre of the holes. Pull out the screws together with the coloured plastic spacer. [. . . ] Pull out the screws together with the coloured plastic spacer. To seal the holes insert the supplied plastic caps B in the wide part of the hole and slide them in the direction of the arrow until they click into place. Important: Keep the transport bolts and the wrench for further transporting of the appliance and in this case refit the transport bolts in reverse order. The appliance must be installed on a solid and level floor surface (if necessary use a spirit level). If the appliance is to be installed on a wooden floor, distribute the weight by placing it on a 60 x 60 cm sheet of plywood at least 3 cm in thickness and secure it to the floor. If the floor is uneven, adjust the 4 levelling feet as required; do not insert pieces of wood etc. Slacken the locknut clockwise (see arrow) using the wrench C supplied. Lift slightly the machine and adjust the height of the foot revolving it. In case the drain hose is installed as shown below: Unhook it only from the right clip (see arrow). Connect the drain hose to the siphon or hook it over the edge of a sink by means of the “U” bend. Fit the “U” bend E, if not already installed, at the end of the drain hose. do not use extension leads or multi sockets. The electrical power cable must be replaced exclusively by a licensed electrician. Electrical connections must be made in accordance with local regulations. The appliance must only be built under using the intermediate cover panel of the UBS base set. This can be obtained from specialist dealers or After Sales Service. [. . . ] Electrical connections must be made in accordance with local regulations. The appliance must only be built under using the intermediate cover panel of the UBS base set. This can be obtained from specialist dealers or After Sales Service. [. . . ]