User manual WHIRLPOOL WAC 7400/1 PRODUCT FICHE

[. . . ] In case of heavy soiling or stains, you can add an oxygen-based bleach additive which can be used at 95°C. This programme eliminates bacteria, ensuring sanitization of your laundry. Normally to heavily soiled bed linen, table linen and underwear, towels, shirts etc. Normally to heavily soiled cotton laundry washable at 60°C. [. . . ] Faster alternative to “Cotton” programme for washing your cotton laundry at 60°C. Heavily soiled laundry made of artificial fibres (like polyester, polyacryl, viscose etc. ) or their blends with cotton. Yes Yes Cotton with prewash 95 °C Cotton 95 °C Cotton 40 - 60 °C Cotton rapid 60 °C Synthetics with prewash 60 °C Synthetics 30 - 40 - 60 °C Delicates 30 °C Quick wash 30 °C Wool Cold - 40 °C Handwash 40 °C Rinse & Spin Spin Short Spin Drain ❉ ❉ ❉ ❉ ❉ ❉ ❉ ❉ ❉ ❉ ❉ — — — ❉ ❉ ❉ ❉ ❉ ❉ ❉ ❉ ❉ ❉ ❉ ❉ ❉ — ❉ ❉ ❉ ❉ ❉ ❉ ❉ ❉ ❉ ❉ ❉ — — — max. 95 °C 6. 0 95 °C 6. 0 — — — Yes Yes max. Yes max. 40 - 60 °C 6. 0 Yes max. 60 °C 3. 0 Yes max. 60 °C 3. 0 Normally soiled garments made of artificial fibres (like polyester, polyacryl, viscose etc. ) or their blends with cotton. 30 - 40 - 60 °C 30 °C 30 °C 1. 0 1. 5 3. 0 Curtains and delicate clothing, dresses, skirts, shirts and blouses. Shortly worn clothing made of cotton, polyester, polyamide and blends with cotton. Brief programme to refresh your laundry. Only woollens, labelled with the Woolmark and identified as machine washable. Textiles made of linen, silk, wool and viscose marked as “handwashable”. Same as the last rinse and the final spin in the “Cotton” programme. Same as spin cycle in the “Cotton” programme. Same as spin cycle in the “Wool” programme. Press the “Start/Pause” button again. The new Consumption values were measured in normalized conditions in compliance with Standard IEC/EN 60 456. Consumption data in the home may vary with respect to the values in the table in relation to the water supply pressure and temperature, the load and the type of wash. Water and energy consumption data refer to the default setting of the programmes; selecting special options or modifying spin speed or temperature will change the consumption data. The programme duration may differ from the values indicated above as it depends on the operation conditions applicable at that time (see also “Troubleshooting Guide” in your Instructions for Use). * Reference programmes for Energy Label. ADD DETERGENTS, CLOSE THE DOOR AND SELECT THE PROGRAMME Add detergent as indicated on the front page and as described in the chapter “Detergent and Additives” in your Instructions for Use. • Turn the programme selector to the desired programme and temperature. The indication lamp next to the “Start/Pause” button blinks. • Particularly useful if you want to postpone spinning to a later time, or if you want to drain only. Note: The programme stops to “Rinse hold” at the time the “Rinse hold” light in the programme sequence indication is on. The indication lamp next to the “Start/ Pause” button blinks. [. . . ] The indication lamp next to the “Start/ Pause” button blinks. : ; the programme programme continues at the same position where the previous programme was interrupted. Do not add detergent for this programme. CANCEL A RUNNING PROGRAMME BEFORE THE END The “Reset” button end. • cancels a programme before the Terminate the “Rinse hold” option • Press the “Start/Pause” button Press and hold the “Reset” button for a few SELECT ANY DESIRED OPTION Push the button of any option desired - the respective indication lights up. [. . . ]