User manual WHIRLPOOL WAK4312 PRODUCT FICHE

[. . . ] Same as the last rinse and the final spin in the “Cotton” programme. in this programme spinning is intensive. Same as the spin cycle in the “Cotton” programme. Same as the spin cycle in the “Wool” programme. [. . . ] €¢ If you select “Rinse hold” do not leave items to soak for too long. Note: The programme stops to “Rinse hold” at the time the “Rinse hold” lights in the preogramme sequence indication is on. The indication lamp next to the “Start” button blinks. Terminate the “Rinse hold” option: • Press the “Start” button; the programme will terminate automatically with the final spin cycle for the present wash programme. €¢ If you do not wish to spin the clothes, turn the programme selector knob to the “Drain” programme and press the “Start” button. “Variable spin” button • Every programme has a predefined spin speed. €¢ Press the button to set another spin speed. €¢ If spin speed “0” is selected, the final spinning is cancelled but intermediate spin peaks remain during rinse. START DELAY The “Start delay” allows to run the machine at the consumer’s convenience, for example at night when electricity is cheaper. Do not use liquid detergent when activating “Start delay” option. • Select programme , temperature and options. Check whether the drain hose is kinked or the filter must be cleaned: in the latter case refer to the Instructions for Use (“Removing the Filter”). PROGRAMME END • All the lights of the programme sequence indicator are off, and the “Door open” indication lights up. Turn the programme selector to the “Off/O” position. Leave the door ajar to allow the drum to dry. cHANGE PROGRAMME AND/OR OPTIONS AFTER PROGRAMME START 1. Press the “Start” button to pause the programme. Select the new programme (with temperature), any options and another spin speed if you want. The new programme continues at the same position where the previous programme was interrupted. Do not add detergent for this programme. cANCEL (RESET) A RUNNING PROGRAMME BEFORE THE END The “Reset” button cancels a programme before the end. €¢ Press the “Reset” button for at least 3 seconds. [. . . ] unsuitable combinations of options are deselected automatically. €œClean+” button • Choose this option if you use an in-wash additive for stain removal (powder, for example “Vanish”) - it will optimize the additive’s efficiency to get better wash performance and stain removal. €¢ Selectable for programmes “Cotton” and “Synthetics”; choose temperature of 30 or 40°C and use with maximum load. €¢ Add an appropriate amount of in-wash additive for stain removal (powder) to the main wash chamber, together with your detergent (only use powder detergent with this option). [. . . ]