User manual WHIRLPOOL WBC3725 A X PROGRAM CHART

[. . . ] Note: Do not obstruct the air intake area with food items. The fan will run ONLY when the compressor is in operation. Cooler compartment Rating plate with commercial name 5. [. . . ] - The internal temperatures of the appliance depend on the ambient temperature, frequency of opening the doors, as well as location of the appliance. Temperature setting must consider these factors. - The appliance accessories are not suitable for washing in dishwasher. D GB F NL E P I GR S N Remember to turn off the fan when there is a lower ambient air temperature. If the appliance has the fan it can be equipped with the antibacterial filter. Remove it from the box (found in the crisper drawer (item 7) and insert into the cover of fan (item 1b). The replacement procedure is attached with the filter. HOW TO START THE APPLIANCE After plugging the appliance to the mains, it starts the operation automatically. The indicator lamps on the control panel light up for approximately 1 second, and after initialization process, setpoint is displayed. Note: - If food is placed in the refrigarator before the appliance has cooled completely, it may deteriorate. - If fresh food is loaded in freezer position 3 on control panel should be chosen. CONTROL PANEL DESCRIPTION 1. 6. extra low temperature low temperature “ECO GREEN” position (depending on the model) high temperature temperature selection/stand-by (3 sec. ) pushbutton internal light switch OPERATION DESCRIPTION Temperature adjustment is made with pushbutton (5). Temperature setpoint is done for both compartments at one time – fridge and freezer. At first plug-in of appliance factory setpoint is chosen – medium position (ECO Green, depending on model). DK FIN PL CZ SK H RUS BG RO PRODUCT SHEET Following table shows set-points level high temperature GB The appliance will work preserving the food stored, but it is necessary to contact after-sales service and provide alarm code. low temperature extra low temperature DEFROSTING THE FREEZER COMPARTMENT The freezer should be defrosted once or twice a year or when excessive frost is present (3 mm thickness). The amount and rate at which frost accumulates depends on room conditions and how often the door is open. To defrost the unit, switch off the freezer compartment or the whole appliance, depending on the model, and remove all food products. Leave the freezer door open to allow the frost to melt. For appliances in figure only pull out the defrost water drain and place a container under the drain. When the operation is completed, put back the defrost water drain. Switch the freezer compartment, or the whole appliance, back on and store the food inside. Description Lamp OFF Lamp ON GUIDE TO SELECTING FUNCTIONS Temperature selection / stand-by pushbutton is used to set desired temperature level, from warmest through lower to coldest . [. . . ] The defrost water is automatically run into a drain hole and collected in a container, where it evaporates. ABNORMAL APPLIANCE OPERATION When the product is plugged in to the mains, during first 10 minutes of its performance, possible temperature sensor failure will be displayed according to following table: Refrigerator sensor failure Freezer sensor failure Refrigerator & freezer sensor failure Do not leave the bulb uncovered. Description Lamp OFF Lamp Flashing D GB F NL E P I GR S N DK FIN PL CZ SK H RUS BG RO 5019 637 01052/A Always disconnect the refrigerator from the power supply before replacing any light bulb. If the inside light is not working, it is necessary to: 1. Remove the light cover: put the fingers into the side ventilation holes (1), stretch the cover gently and move it upwards. [. . . ]