User manual WHIRLPOOL WDF111PABB DIMENSION GUIDE

[. . . ] All safety messages will follow the safety alert symbol and either the word “DANGER” or “WARNING. € These words mean: DANGER WARNING You can be killed or seriously injured if you don't immediately follow instructions. You can be killed or seriously injured if you don't follow instructions. All safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and tell you what can happen if the instructions are not followed. [. . . ] Use pliers to squeeze clamp open and move into position. If the drain hose was cut, use a 1¹⁄₂" to 2" (3. Use a rubber hose (not provided) with screw-type clamps (not provided) to connect from air gap to disposer inlet. 10 Option D, No waste disposer – with air gap Prepare Dishwasher WARNING Tip Over Hazard Do not use dishwasher until completely installed. Doing so can result in serious injury or cuts. WARNING Excessive Weight Hazard Use two or more people to move and install dishwasher. Failure to do so can result in back or other injury. Use pliers to squeeze clamp open and move into position. If the drain hose was cut, use a 1¹⁄₂" to 2" (3. Use a rubber hose (not provided) with screw-type clamps (not provided) to connect from waste tee to air gap. Using the precut slots in the insulation, fasten the insulation over the molded hooks on the tub. Use ¹⁄₄" hex-head socket, nut driver or Torx® T20® screwdriver and previously removed screw to secure cover. If power cord supplied model, remove the first tie strap closest to the plug to maximize the cord length. NOTE: Do not plug into outlet until instructed to do so. 13 Determine Cabinet Opening Your dishwasher has leveling legs. The following provides instructions to adjust the leveling legs to set the dishwasher to the correct height for your cabinet opening. Measure height of cabinet opening from underside of countertop to floor where dishwasher will be installed (you will need to measure the lowest point on the underside of the countertop and the highest point on the floor). refer to “Dishwasher Height Adjustment Chart” to adjust the leveling legs. NOTE: If the minimum cabinet opening height is less than 33⁷ „₈" (86 cm), the rear leveling legs and spacers can be removed for additional clearance. This will allow the dishwasher to fit into a 33¹⁄₂" (85. 1 cm) high cabinet opening, but the dishwasher will be more difficult to move. Rear and front leveling legs are preset at the factory for 34¹⁄₂" [87. [. . . ] If needed, see website for animated representation of this step. 21 WARNING ■ ■ ■ Check Operation Read the Dishwasher User Instructions that came with your dishwasher. Check that all parts have been installed and no steps were skipped. Start dishwasher and allow it to complete the shortest wash cycle. [. . . ]