User manual WHIRLPOOL WDF320PADB ENERGY GUIDE

[. . . ] START BUTTON RESET FUNCTION: Press this button for at least 2 seconds; the selected programme and options will be cancelled. Main failure displays (repeated flashing of the START indicator lamp) can be cancelled by RESETTING. Detailed instructions are given in chapter “What to do if. . . ”. START DELAY option MULTI ZONE option POWER CLEAN option ON/OFF BUTTON (see at right for options description) Table of programmes Consumption Loading instructions Detergent Litres kWh Minutes 1) RINSE AID INDICATOR When lit, the rinse aid dispenser needs to be refilled. P 1 2 3 4 5 6 7 1) 2) 3) Programmes Available options Aqua Steam 40-70°C Normally or heavily soiled crockery, including pots and pans. Thanks to Delay steam action, soaking or hand Multizone pretreatment is no longer needed. [. . . ] The wash cycle can be interrupted at any time by pressing START (see chapter “What to do if. . . ”). Change the programme in progress: • Press the START button (for 2 seconds) until the START indicator lamp switches off. • (Water drains for up to 60 seconds). • Select a new programme • Press the START button. Switch off the appliance Everything o. k. . . . Exercise caution when opening the door: beware of hot steam. Only press the OFF button once the START indicator lamp has switched off. Unload the appliance, starting from the lower rack in order to avoid any residual drips of water falling onto crockery below. Maintenance and care Maintenance and care Screw on filter cylinder NOTE MARK!Unscrew filter cylinder, remove it and fine sieve. . . Insert Filters Check and clean if necessary Rectifying minor faults yourself . . . 10 Insert and screw on lower and upper arms tightly. Clean spray nozzles under running water (use toothpicks if necessary) . . . Spray arms Remove blockages/ deposits. GB -5- What to do if. . . If a fault occurs, before contacting the After-sales Service, make the following checks to try and remedy the problem. Most faults can be remedied by taking the following courses of action, quickly restoring normal appliance operation. - Set “Detergent type” option; if this option is not available, it is normal for the salt indicator to light up. - In areas with very hard water, more regeneration salt needs to be added (see page 2 “How to set water hardness”). - Close the salt reservoir cap properly. - If you use a combined action detergent, try adding more rinse aid. - Synthetic materials do not dry well; if wet at end of cycle, wipe dry. Clean dishes left in dishwasher for a long time after end - In this situation, the presence of drops of water on dishes and on the sides of the dishwasher is normal. when using “delayed start” option). releasing the door 5 minutes before removing the dishes. Incorrect arrangement of the concave items in the rack. - Arrange crockery so that water does not collect in cavities. - Increase the dosage of rinse aid - see page 3, “Adding rinse aid”. - The rapid programme is intended for quickly washing lightly soiled dishes. [. . . ] - The open dishwasher door can only support the weight of the loaded rack when pulled out. Do not rest objects on the open door or sit or stand on it. - Sharp items that might cause injury (e. g. knives), must be placed in the cutlery basket with the sharp end facing downwards. [. . . ]