User manual WHIRLPOOL WDF518SAAW ENERGY GUIDE

[. . . ] All safety messages will follow the safety alert symbol and either the word “DANGER” or “WARNING. € These words mean: DANGER WARNING You can be killed or seriously injured if you don't immediately follow instructions. You can be killed or seriously injured if you don't follow instructions. All safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and tell you what can happen if the instructions are not followed. [. . . ] 9 cm) hole in the right-hand cabinet side, the rear or floor of opening. WARNING: Improper connection of the equipment-grounding conductor can result in a risk of electric shock. Check with a qualified electrician or service representative if you are in doubt whether the dishwasher is properly grounded. Do not modify the plug provided with the dishwasher; if it will not fit the outlet, have a proper outlet installed by a qualified electrician. – For a permanently connected dishwasher: The dishwasher must be connected to a grounded metal, permanent wiring system, or an equipmentgrounding conductor must be run with the circuit conductors and connected to the equipmentgrounding terminal or lead on the dishwasher. If the cabinet is wood, sand hole until smooth. If the cabinet is metal, cover the hole with a grommet (Part Number 302797) included with power supply cord kit. 3 cm) hole in the left-hand cabinet side, the rear or floor of opening. Measure the overall length of the copper tubing required. Attach the copper tubing to the water supply line with a manual shutoff valve. Slowly feed the copper tubing through the hole in the cabinet. Connect Drain Hose to Waste Disposal—No Air Gap IMPORTANT: Always use a new drain hose even when installing a new replacement dishwasher. 8 cm) diameter hole in the cabinet wall or floor on the side of the opening closest to the sink. NOTE: Do not cut the end of the drain hose. Attach the drain hose to the waste disposal inlet with the large spring-type clamp. This connection must be before the drain trap and at least 20" (50. NOTE: It is recommended that the drain hose be looped up and securely fastened to the underside of the counter. Drain trap Do not use dishwasher until completely installed. Doing so can result in serious injury or cuts. 9 WARNING Excessive Weight Hazard Use two or more people to move and install dishwasher. Measure the shortest opening height between the underside of the countertop and the floor where the dishwasher will be installed. If direct wired, check that the power supply wire is on the right-hand side at the front of the cabinet opening. [. . . ] NOTE: Total drain hose length must not exceed 10 ft (3 m) for proper drain operation. Hose and a coupler, connect the two drain hose ends with hose clamps. 6 cm) and check that the space between the inner door and tub is equal on both sides. If spacing is not equal, loosen the bracket screws and shift the tub. [. . . ]