User manual WHIRLPOOL WDT995SAFM INSTALLATION GUIDE

[. . . ] 13 2 DISHWASHER SAFETY Your safety and the safety of others are very important. We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety messages. This symbol alerts you to potential hazards that can kill or hurt you and others. [. . . ] strain relief is provided with the power cord kit. See the “Tools and Parts” section at the front of the guide for part details and orders. Power cord – route cord into terminal box Use a 1/4" nut driver or 1/4" hex head socket wrench to remove the screw that holds the terminal box to the cross brace. Then, tilt the terminal box, free the tab, and lift the terminal box away from the crossbar. Route cord so that it does not touch dishwasher motor or lower part of dishwasher tub. Pull cord through strain relief in terminal box. NOTE: A maximum of 2 power cord supply conductors (12 AWG largest size) plus 1 grounding conductor are permitted in the terminal box. Remove cover Remove the cover by sliding it up and lifting its hooks out of the slot. Connect ground wire to green ground connector in terminal box. Failure to follow these instructions can result in death, fire, or electrical shock. Power cord – connect ground wire Ground wire Tighten strain relief screws to secure cord. Power cord – reinstall terminal box cover and wires Ground screw Remove the ground connector screw on the raised floor inside the box and place it through the ring terminal of the green ground wire of power cord. Reattach and tighten the ground connector screw to the raised floor of the box. Power cord – connect remaining wires Place wires inside terminal box. Replace the cover by inserting the hooks of the terminal cover into the slots in the floor of the terminal box and sliding the cover tight against the back wall where wires come in. Make sure wires are tucked inside the box and not pinched by the cover. Put the terminal box back on the crossbar with the tab in place. Use a 1/4" nut driver and the screw removed in Step 22 to secure the terminal box to the crossbar. Once the terminal box has been remounted on the dishwasher, tuck any excess length or slack over nearby components or clip them back into the nearby clips to help keep them off the floor. select UL Listed/CSA Approved twist-on wire connectors of the proper size. See the “Tools and Parts” section at the front of the guide for part details. Gently tug on wires to be sure both are secured. [. . . ] Place the plastic access panel against the dishwasher leg. Make sure insulation does not interfere with the float assembly. Check access panel edge Check that the lower edge of the access panel touches the floor. Check that the lower edge of the access panel touches the floor. [. . . ]