User manual WHIRLPOOL WED5000DW INSTALLATION GUIDE

[. . . ] Clear the room, building, or area of all occupants. Immediately call your gas supplier from a neighbor's phone. If you cannot reach your gas supplier, call the fire department. For more information, contact your gas supplier. [. . . ] You can stop your dryer anytime during a cycle. Close the door, then touch the START/PAUSE button to start the dry cycle. When the cycle has finished, a "DRY" message will be displayed and the end of cycle signal will sound (if set). (The damp signal sounds during the cycle to indicate when the clothes go from wet to damp. ) Promptly remove garments when cycle is done to reduce wrinkling, or you can make sure the Wrinkle ShieldTM feature is set. Touch the Learn More button to display additional information about using a cycle or feature, if desired. When you are finished, touch DONE to return to the previous screen. Use this cycle to smooth out wrinkles and reduce odor from loads consisting of one to twelve dry items of wrinkle-free cotton, cotton-polyester blend, common knits and synthetic garments to be refreshed by touching the arrow keys up or down to increase or decrease the number of garments. Some cycles, such as Quick Refresh and Enhanced Touch Up, add a small amount of water to the dryer drum after several minutes of tumbling with heat. this will help loosen wrinkles and reduce odors. Steam may also be added as an option with the Wrinkle Shield feature to help minimize wrinkling. Allow space around items for air to circulate. the drying rack does not move , but the drum will rotate. Make sure items do not hang over the edges or between drying rack grille. Items containing foam, rubber, or plastic must be dried on a clothesline or by using the Air Only setting. When the cycle is selected, the Estimated Time Remaining display shows the default time. NOTE: Check the lint screen and remove any lint accumulated from items dried on the drying rack after the cycle is finished. Touching the SOUND & DISPLAY button will access Sound & Display menu, where you can adjust preferences such as screen calibration, end of cycle signal, volume, LCD brightness, language, factory settings, date, time, and custom dry level. To change a setting, touch the icon for that preference and follow the on-screen instructions. If you are having difficulty selecting or dragging the correct icons with the touch screen, for example, if you touch one icon but one adjacent to it is selected instead, the touch screen may need calibration. Follow the on-screen instructions to calibrate the touch screen. Replace inlet hose after 5 years of use to reduce the risk of hose failure. [. . . ] The load may not be contacting the sensor strips. If loads are consistently ending too early, see also Changing the Automatic Dry Default Settings. For one year from the date of purchase, when this major appliance is operated and maintained according to instructions attached to or furnished with the product, Whirlpool Corporation or Whirlpool Canada LP (hereafter "Whirlpool") will pay for Factory Specified Parts and repair labor to correct defects in materials or workmanship that existed when this major appliance was purchased. This limited warranty is valid only in the United States or Canada and applies only when the major appliance is used in the country in which it was purchased. [. . . ]