User manual WHIRLPOOL WEE745H0FE INSTALLATION GUIDE

[. . . ] W10665255D RANGE SAFETY Your safety and the safety of others are very important. We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety messages. This symbol alerts you to potential hazards that can kill or hurt you and others. [. . . ] WARNING Rear position Front position Diagonal (2 options) Wall Mounting Tip Over Hazard A child or adult can tip the range and be killed. Install anti-tip bracket to floor or wall per installation instructions. Move range close enough to opening to allow for final electrical connections. Move range into its final location, making sure rear leveling leg slides into anti-tip bracket. Slide range back so rear range foot is engaged in the slot of the anti-tip bracket. re-engage anti-tip bracket if range is moved. Do not operate range without anti-tip bracket installed and engaged. Failure to follow these instructions can result in death or serious burns to children and adults. Measure the distance from the top of the counter to the floor. Measure the distance from the top of the cooktop to the bottom of the leveling legs. If it is not, adjust the leveling legs to the correct height. The leveling legs can be loosened to add up to a maximum of 1" (2. A minimum of ³⁄₁₆" (5 mm) is needed to engage the anti-tip bracket. NOTE: If height adjustment is made when range is standing, tilt the range back to adjust the front legs, and then tilt forward to adjust the rear legs. When the range is at the correct height, check that there is adequate clearance under the range for the anti-tip bracket. Before sliding range into its final location, check that the antitip bracket will slide under the range and onto the rear leveling leg prior to anti-tip bracket installation. NOTE: If a Trim Kit will be used, the top of the cooktop should be higher than the counter. See the Installation Instructions included with the Trim Kit for the correct height. Move range forward onto shipping base, cardboard or hardboard to continue installing the range, using the following installation instructions. Place level on the oven bottom, as indicated in one of the two figures below, depending on the size of the level. Check with the level side to side and front to back. Remove plastic tag holding three 10-32 hex nuts from the middle post of the terminal block. [. . . ] Continue to push the oven door closed and pull it away from the oven door frame. The drawer is no longer attached to the drawer glides. Using both hands, pick up the drawer to complete the removal. Align the forward drawer notches with the notches in the drawer glides on both sides. [. . . ]