User manual WHIRLPOOL WFE320M0AW DIMENSION GUIDE

[. . . ] 10 General Care & Cleaning . . . . . . . . 11-13 Before You Call Solutions to Common Problems . . . . . . . . . . . . . . . . . . . . . . . . 14 Warranty . . . . . . . . . . . . . . . . . . . . . . . . . Back Page Questions or for Service Call: 1-800-944-9044 (U. S. ) 1-800-668-4606 (Canada) READ AND SAVE THESE INSTRUCTIONS p/n 316417134 (0705) Welcome & Congratulations Congratulations on your purchase of a new range! [. . . ] DO NOT cover the insert with aluminum foil. Place broiler pan on rack; make sure the broiler pan with the insert is positioned as shown (See Fig. 1). Be sure front of pan is positioned correctly in rack. Slide the broiler drawer all the way into the range. Press and hold the broil or the or Fig. 3 NOTE: The broiler pan & insert allows grease to drain and be kept away from the high heat of the broiler (See Fig. DO NOT cover the insert with foil; the exposed grease could ignite. until the desired broil setting level appears in the display. Press the for HI (high) for LO (low) broil. Most foods can be broiled at the HI broil setting. Select the LO broil setting to avoid excess browning or drying of foods that should be broiled to the well-done stage. Broil on one side until food is browned; turn and cook on the second side. The oven temperature adjustment has be accepted by the oven control and the display will return to the time of day. Notes: The oven temperature adjustment may be made if your oven control has been set to operate in the (Celsius) °C Temperature Display Mode. In this case each press of the or key will adjust in 1°C increments upward (maximum +18°C) or downward (maximum -18°C), depending on which arrow key pad is pressed. 10 General Care & Cleaning (Cleaning Chart) Surfaces Aluminum (Trim Pieces) & Vinyl Glass, Painted Plastic Body Parts & Control Knobs How to Clean Use hot, soapy water and a cloth. For general cleaning, use hot, soapy water and a cloth. For more difficult soils and built-up grease, apply a liquid detergent directly onto the soil. DO NOT use abrasive cleaners on any of these materials; they can scratch. Before cleaning the control panel, turn all controls to OFF and remove the control knobs. To remove, pull each knob straight off the shaft. Squeeze excess water from the cloth before wiping the panel; especially when wiping around the controls. Excess water in or around the controls may cause damage to the appliance. To replace knobs after cleaning, line up the flat sides of both the knob and the shaft, then push the knob(s) into place. [. . . ] Products with original serial numbers that have been removed, altered or cannot be readily determined. Product that has been transferred from its original owner to another party or removed outside the USA or Canada. Rust on the interior or exterior of the unit. Products purchased "as-is" are not covered by this warranty. [. . . ]