User manual WHIRLPOOL WGD4900XW VENTILATION SPECIFICATION

[. . . ] Optional Equipment: (Not supplied with dryer) Level Pliers Refer to your “Use and Care Guide” for information about accessories available for your dryer. Location Requirements Adjustable wrench that opens to 1" (25 mm) or hex-head socket wrench Caulking gun and compound (for installing new exhaust vent) Utility knife Putty knife ■■ 4 You will need: A location allowing for proper exhaust installation. –■ If you are using power supply cord, a grounded electrical outlet located within 2 ft. € ■■ A sturdy floor to support dryer and a total weight (dryer and load) of 200 lbs. [. . . ] Burner input adjustments are not required when the dryer is operated up to this elevation. Rating shown on the model/serial number plate is required for each 1, 000 ft. Gas supply pressure testing ■■ The dryer must be disconnected from the gas supply piping system during pressure testing at pressures greater than 1/2 psi. If local codes permit, use a new flexible stainless steel gas connector (Design Certified by the American Gas Association or CSA International) to connect your dryer to the rigid gas supply line. Use an elbow and a 3/8" flare x 3/8" NPT adapter fitting between the stainless steel gas connector and the dryer gas pipe, as needed to prevent kinking. –■ If you are using Natural Gas, do not use copper tubing. 1 m) should use larger tubing and a different size adapter fitting. Failure to follow these instructions can result in death, fire, or electrical shock. It is also recommended that a separate circuit serving only this dryer be provided. WARNING: To reduce the risk of fire, this dryer MUST BE EXHAUSTED OUTDOORS. In the event of malfunction or breakdown, grounding will reduce the risk of electric shock by providing a path of least resistance for electric current. refer to the manufacturer’s instructions. Special provisions for mobile home installations: The exhaust vent must be securely fastened to a noncombustible portion of the mobile home structure and must not terminate beneath the mobile home. Over-The-Top installation (also available with one offset elbow) Determine vent path: ■■ ■■ ■■ ■■ ■■ Periscope installation Select route that will provide straightest and most direct path outdoors. Plan installation to use fewest number of elbows and turns. When using elbows or making turns, allow as much room as possible. NOTE: The following kits for close clearance alternate installations are available for purchase. Determine vent length and elbows needed for best drying performance: ■■ Use following “Vent System Chart” to determine type of vent material and hood combinations acceptable to use. secure vent to exhaust hood with 4" (102 mm) clamp. Run vent to dryer location using straightest path possible. Do not use duct tape, screws, or other fastening devices that extend into interior of vent to secure vent, because they can catch lint. Tighten and adjust leveling legs Connect vent to exhaust outlet If dryer is not level, prop up using a wood block. [. . . ] Lift door until top screws in dryer cabinet are in large part of hinge slot. Insert screws in hinge holes on dryer cabinet NOTE: 2 people may be needed to reinstall door. Insert screws into the bottom holes on left side of dryer cabinet. Slide door up so screws are in bottom of slots. [. . . ]