User manual WHIRLPOOL WGD8500DW USE & CARE GUIDE

[. . . ] Proper venting will reduce your drying times and improve your energy savings. The venting system attached to the dryer plays a big role in good air flow. blocked or crushed vents as well as improper venting installation will reduce air flow and dryer performance. Service calls caused by improper venting are not covered by the warranty and will be paid by the customer, regardless of who installed the dryer. [. . . ] 12 Dryer Care CLEANING THE DRYER LOCATION Keep dryer area clear and free from items that would block the air flow for proper dryer operation. This includes clearing piles of laundry in front of the dryer. CLEANING THE LINT SCREEN Every load cleaning The lint screen is located in the door opening of the dryer. The control panel has an indicator light “Check Lint” to remind you to clean the lint screen after each load. Roll lint off the screen with your fingers. Do not rinse or wash screen to remove lint. Close the lint screen and push firmly back into place. cLEANING THE DRYER INTERIOR To clean dryer drum 1. Use a mild hand dish detergent mixed at a low concentration with very warm water, and rub with a soft cloth. Tumble a load of clean clothes or towels to dry drum OR Use a microfiber cloth and hot water in a spray bottle  to clean the drum and a second microfiber towel to dry. NOTE: Garments that contain unstable dyes, such as denim blue jeans or brightly colored cotton items, may discolor the rear of the dryer interior. Periodically inspect and replace inlet hose if bulges, kinks, cuts, wear, or leaks are found. When replacing your inlet hose, record the date of replacement. Non-Use or Storage Care Operate your dryer only when you are at home. If you will be on vacation or not using your dryer for an extended period of time, you should: 1. This helps to avoid unintended flooding (due to a water pressure surge) while you are away. Moving Care For power supply cord-connected dryers: 1. Disconnect the water inlet hose from faucet, then drain the hose. Make sure leveling legs are secure in dryer base. Plug in dryer or reconnect power as described in the Installation Instructions. wARNING Electrical Shock Hazard Disconnect power before servicing. Replace all parts and panels before operating. [. . . ] Cosmetic damage including scratches, dents, chips, and other damage to appliance finishes unless such damage results from defects in materials and workmanship and is reported to Whirlpool within 30 days. Discoloration, rust, or oxidation of surfaces resulting from caustic or corrosive environments, including but not limited to, high salt concentrations, high moisture or humidity, or exposure to chemicals. This product is intended for in-home repair. Travel or transportation expenses for service in remote locations where an authorized Whirlpool servicer is not available. [. . . ]