User manual WHIRLPOOL WOS51EC7AW USE & CARE GUIDE

[. . . ] Appliance This appliance is marked in compliance with European Directive 2002/96/EC on Waste Electrical and Electronic Equipment (WEEE). By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. The symbol on the appliance or accompanying documentation indicates that this product should not be disposed of as unsorted municipal waste but must be taken to a collection point for the treatment of WEEE. Disposal must be carried out in accordance with local environmental regulations for waste disposal. [. . . ] Regular cleaning and maintenance is essential for correct hood operation and good performance. Frequently clean all encrustations from dirty surfaces to prevent the accumulation of grease. Do not “flambé” food under the hood. The room must have adequate ventilation when the hood is used at the same time as appliances operating on gas or other fuels. The discharge air must not be eliminated in a duct used to remove fumes produced by appliances operating on gas or other fuels, but must have a separate outlet. All the national regulations on air discharge envisaged by art. 7. 12. 1 of CEI EN 603352-31 must be observed. If the hood is used together with other appliances operating on gas or other fuels, the negative pressure in the room must not exceed 4 Pa (4 x 10-5 bar). Therefore, make sure the room is adequately ventilated. 23. Do not leave pans unattended when frying, since the cooking oil could catch fire. Make sure the lamps are cold before touching them. • Grease filter Carbon filter (“Air recirculation mode”, see following page) The carbon filter cannot be washed or regenerated. In some cases, carbon filters can be washed, but only when specified in the attached Product Description Sheet. Replace the carbon filter (normal usage) every 6 months (Rectangular carbon filter) every 4 months (Circular carbon filter). Replacing bulbs 1. When replacing the bulb, be sure it is cool before touching it and check the wattage. Pull out the steam-collecting drawer (depending on model). Open the grille or light fixture and remove the grease filter. Remove the burnt-out bulb and replace it with a new one of the same wattage. Close the grille, light fixture or metal grease filter. Cleaning the hood Use a soft cloth with methylated spirits or a mild liquid detergent. never clean the appliance with high pressure water or steam cleaning equipment. WARNING: Failure to remove oil/grease (at least once a month) could result in fire. Important: Failure to observe the instructions for cleaning the appliance and replacing or washing the filters may cause a fire. TROUBLESHOOTING GUIDE Hood does not work: • • • • • • Is the power plug properly inserted in the mains socket? [. . . ] Some models are fitted with a plastic deflector that closes off the rear outlet. Put the cover (if fitted) in the upper outlet. A The hood is usually set up for using the upper exhaust outlet. Warning!If the hood has a carbon filter, this should be removed. Filter Hood ( - see also installation sheet) Check that the switch inside the hood (if fitted) is on position “A” Extractor; if not, set it to this position. F Air is filtered through a carbon filter and returned to the room. [. . . ]