User manual WHIRLPOOL WOS92EC0AS DIMENSION GUIDE

[. . . ] All safety messages will follow the safety alert symbol and either the word “DANGER” or “WARNING. € These words mean: DANGER WARNING You can be killed or seriously injured if you don't immediately follow instructions. You can be killed or seriously injured if you don't follow instructions. All safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and tell you what can happen if the instructions are not followed. [. . . ] The model/serial number rating plate is located under the control panel on single ovens and under the control panel on the upper oven cavity on double ovens. A A For power requirements for models KEBK171B, KEBK101B, KEBK276B, KEBK206B, KEBS179B, KEBS109B, KEBS277B, KEBS279B, KEBS207B and KEBS209B, refer to the following table. Model/serial number plate 208 VAC Models rated from 7. Connect directly to the circuit breaker box (or fused disconnect) through flexible, armored or nonmetallic sheathed, copper cable (with grounding wire). see “Make Electrical Connection” section. Flexible conduit from the oven should be connected directly to the junction box. For power requirements for models KEBU109B and KEBU209B, refer to the following table. Decide on the final location for the oven. Avoid drilling or cutting into house wiring during installation. Locate the oven door latches in both corners of the oven door, and rotate the latches forward to the unlocked position. WARNING Excessive Weight Hazard Use two or more people to move and install oven. Double Ovens The positioning of the oven feet allow a double oven to be installed in a cutout height between 48⁷ Refer to the following instructions to position the feet for the size of your cabinet cutout. 1 cm) The oven feet do not need to be installed. the oven is configured correctly as received. Rotate the foot 90° so the short side of the foot is positioned toward the top of the oven. Reinstall the foot to the spacer using the #8-18 x ³⁄₈" screw previously removed. In the same manner, remove, rotate and reinstall the feet on the right rear, left front, and left rear of the oven. Using 2 or more people, place the oven in its upright position. Using 2 or more people, place the oven on its back on a covered surface. Using 2 or more people, place the oven in its upright position. Install a foot on the left rear spacer using a #8-18 x ³⁄₈" screw. NOTE: Position the foot so the long side of the foot is facing toward the top of the oven. [. . . ] Untwist white wire from green (or bare) ground wire coming from the oven. Connect the 2 white wires (F) together using a UL listed wire connector. Connect the green (or bare) ground wire (H) from the oven cable to the green (or bare) ground wire (in the junction box) using a UL listed wire connector. Route the flexible conduit from the oven to the junction box through a UL listed or CSA approved conduit connector. [. . . ]