User manual WHIRLPOOL WRF57R18DM USE & CARE GUIDE

[. . . ] We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety messages. This symbol alerts you to potential hazards that can kill or hurt you and others. All safety messages will follow the safety alert symbol and either the word “DANGER” or “WARNING. [. . . ] If the refrigerator seems unsteady or rolls forward when the door is pulled open, adjust the brake feet. To Steady the Refrigerator: ■ Open the refrigerator door. Using a ¹⁄₄" hex driver, turn both brake feet clockwise the same amount until the brake feet are snug against the floor. If not satisfied, continue to adjust the brake feet by half turns of the screw until the refrigerator does not roll forward when the door is opened. OPERATING YOUR REFRIGERATOR Ensuring Proper Air Circulation In order to ensure proper temperature, you need to permit proper airflow in the refrigerator. As shown in the illustration, cool air enters from the refrigerator wall and moves down. The air then recirculates through the vent near the bottom. Using the Control The temperature control is located at the top front of the refrigerator compartment. Temperature Control For your convenience, the temperature control is preset at the factory. When you first install your refrigerator, check that the control is still set to the recommended setting as shown. recommended setting is the center snowflake. The lock is spring loaded, so the key cannot be left in the lock. –  Adjusting Control If you need to adjust the temperature in the refrigerator compartment, press the TEMP SETTING button to display the desired temperature setting from the snowflake on the left (least cold) to the snowflake on the right (coldest). NOTE: Except when starting the refrigerator, do not adjust the control more than one setting at a time. This alert feature will sound a continuous alert tone and repeatedly flash a red light on the control panel. The tone can be turned off by pressing the TEMP SETTING button on the control panel once. As you press the TEMP SETTING button, the red light will then also change from flashing to continuously illuminated. The red light will remain illuminated until the refrigerator temperature falls below 54°F (12°C). NOTE: If the red light on the control panel is repeatedly flashing, but the alert tone is not sounding, this means that an over temperature condition has occurred but the refrigerator temperature has since returned to below 54°F (12°C). To turn off the red light indicator for this condition, press the TEMP SETTING button on the control panel once. Remove the shelf by lifting straight up, and pulling the shelf out. Replace the shelf by lowering the shelf onto the supports on the side wall. [. . . ] Please take a few minutes to review the Troubleshooting or Problem Solver section of the Use and Care Guide, scan the QR code on the right to access additional resources, or visit www. And Canada, direct all requests for warranty service to: Whirlpool Customer eXperience Center In the U. Com/product_help If outside the 50 United States or Canada, contact your authorized Whirlpool dealer to determine whether another warranty applies. ONE YEAR LIMITED WARRANTY WHAT IS COVERED For one year from the date of purchase, when this major appliance is installed, operated and maintained according to instructions attached to or furnished with the product, Whirlpool Corporation or Whirlpool Canada LP (hereafter “Whirlpool”) will pay for Factory Specified Replacement Parts and repair labor to correct defects in materials or workmanship that existed when this major appliance was purchased, or at its sole discretion replace the product. [. . . ]