User manual WHIRLPOOL WRS965CIAE ENERGY GUIDE

[. . . ] Installation of the 1175R/1175WC/1175BEV . 4 4 5 5 6 7 7 8 9 10 11 11 11 12 12 12 12 13 13 13 1 Follow Safety Precautions IMPORTANT PLEASE READ all instructions completely before attempting to install or operate the unit. · This unit requires connection to a grounded (threeprong), polarized receptacle that has been placed by a qualified electrician in accordance with applicable electrical codes. Safety Alert Definitions Safety items throughout this guide are labeled with a Danger, Warning or Caution based on the risk type: DANGER Danger means that failure to follow this safety statement will result in severe personal injury or death. WARNING Warning means that failure to follow this safety statement could result in serious personal injury, or death. CAUTION Caution means that failure to follow this safety statement may result in minor or moderate personal injury, property or equipment damage. www. U-LineService. com 2 06/2006 1175R, 1175WC and 1175BEV Models General Precautions Use this appliance for its intended purpose only and follow these general precautions along with those listed throughout this guide: 2 Inspect and Plan You have received a carton containing your 1175R Refrigerator, 1175WC Wine Captain® or 1175BEV Beverage Center with a package inside containing a Use and Care Guide and a Product Registration Card. Complete and mail the Product Registration Card or register online at www. U-LineService. com. [. . . ] · If the ambient temperature is expected to drop below 45°F (7°C), drain all water from the unit to prevent freezing damage not covered by the warranty. · For best performance, keep the unit out of direct sunlight and away from heat generating equipment. · For best performance and life outdoors, place under a counter or provide shelter of some kind. Figure 10 ULIN_0110_A Figure 9 ULIN_0109_A 9. Relocate plastic spacer/bushing (Figure 9) on bottom of door to the opposite side. Clean out bushing hole in door bottom if necessary. 10. Align flat edge of top hinge with outer edge of unit and fasten upper hinge to unit (four screws) (Figure 10). Partially tighten screws until door is aligned. Tighten upper and lower hinge screws securely. Replace four plastic plugs removed in Step 4 into holes on top of unit. Replace screws in holes in bottom of unit on opposite side. Holding door gasket out of the way, replace handle on door, making sure it is seated properly on insert and that screw holes line up. Install two small screws removed in Step 3. Starting at the corners and working inward, push door gasket into place on door. Place door on bottom hinge pin and install upper hinge screw. Go on to 5 Adjust Door. Figure 15 ULIN_0162_A 3. Press the left rack release lever (Figure 15) down, and at the same time, lift the corresponding right rack release lever up, and pull the rack out until it is free of the tracks and the cabinet. IMPORTANT Do not remove the track side rails from the cabinet. Align the left and right rack channels with the tracks in the cabinet, and ensuring an even track engagement on both sides, gently push the rack into the cabinet until it stops. Before reloading the rack, ensure proper operation of the travel stops in the left and right track rails by pulling the rack out gently until it completely stops. 06/2006 9 www. U-LineService. com 1175R, 1175WC and 1175BEV Models Wood Trim Finishing Interior components of your U-Line unit are equipped with a natural wood trim for appearance and durability. Although this wood trim has been coated with a clear sealer at the factory, it is recommended that the trim be stained (if desired), and receive a final finish coating prior to the unit going into full-time service. WARNING To prevent permanent damage to the inner liner of your unit, the wood trim MUST be removed from the unit for staining and/or finishing. Allow stain/finish to dry thoroughly (at least 24 hours per coat) in accordance with the product manufacturer's instructions prior to reinstallation. Failure to do so may cause the inner liner of the unit to have a permanent odor, which is not covered by the warranty. [. . . ] If it is not, use the following procedure. Adjusting Door Alignment IMPORTANT Properly aligned, the door's gasket should be firmly in contact with the cabinet all the way arond the door (no gaps). Carefully examine the door's gasket to assure that it is firmly in contact with the cabinet. Also make sure the door gasket is not pinched on the hinge side of the door. 7" 23-7/16" 1175R, 1175WC and 1175BEV Units 1. Loosen (do not remove) top and bottom hinge screws. [. . . ]